answersLogoWhite

0

On a 94 Ford 7.3, the throttle POS sensor is on the throttle body. It is on the opposite side of the throttle linkage.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Were is the camshaft position sensor on a 92 ford explorer?

a92 ford exp. has no camshaft pos. sencor. it has a crankshaft pos. censor.


Where is the EGR valve pos sensor on a 01 ford econoline van?

The 2001 Ford E GR valve position sensor is attached to the firewall, in the engine compartment. The sensor will be on the drivers side of the engine compartment.


What is a Ford pos?

ford p.o.s is a ford piece of s**t


Does pos stand for in Ford POS?

Piece of s##t, taken from the movie "Men in Black".


When you start 2000 s-10 rpms go to 3000 then down to 500 back to 3000 then 500 and so on is this a throttle pos sensproblem?

check for a vacuum leak on the throttle body


Does a ford battery with 6 volt positive ground need to be charged backward?

Nope, same as any other. pos to pos, neg to neg


Where is cam position sensor on 99Honda Accord with a four cylinder?

This model Honda (99Accord EX w/4 cyl.) does not have a CMP (cam pos. sensor). It has a cyl. pos. sensor. (CYP) Both sensors tell the computer when #1 cyl. is @ top dead center on the comp. stroke. These sensors are specific to manufacturer and model. This sensor is located in the distributor.


Why does your 1996 corsica 3.1 idle super high replaced throttle pos sensor still does it has great vacuum?

It wouldn't make much of a vacuum leak to cause the engine to idle at high RPM. First check for vacuum leaks even though you may still have good manifold vacuum.


Why is there a Loud hum sound on 2003 ford explorer any ideas?

it's just a POS


The location in a retail or grocery store where a consumer pays for goods or services is the?

POS (point of sale)


Where is the crankshaft sensor located on a '96 Crown Vic?

on passenger front of the engine block between the a/c compressor and front cover.you will have to move the compressor out of the way to get the sensor out. Answer : Do not bother unbolting the compressor, just unplug any wires that are in the way, including the Crank. pos. sensor. Does the car crank but no start, I ask because that is usually the sympton of the crankshaft pos. sensor. Long extensions will help get to the bolts, swivels or wobble extensions if needed.


Where is crank pos sensor on dodge 318 gasoline engine?

Behind the passenger side head in the top of the bell housing.

Trending Questions
Where is the fuel pump relay fuse located on a 1989 Chevrolet Caprice? What is the best technique to use if you are approaching another driver with their high beams? Does Briggs and stratton 2265X8c mower have an oil filter? How do you change low beam bulb in 2001 vito? Idle problem when changing the battery on new Toyota? How to change a fuel filter in a 1993 Isuzu Rodeo or Honda Passport? Why wont your manual transmission come out of gear? What does carquest 84035 filter fit? 1991 S10 43 drags when starting replaced the starter battery cable to starter and helped for 1 day started but after dragging down the battery and got worse changed battery but still same problem? How much fork oil in suzuki gz 125 hs marauder? How do you change the rear wiper blade on a 2004 Chrysler Pacifica? Where are the coolant drain plugs on a 1990 Nissan Harbody Truck? What size battery does a 1998 ford Crown Victoria use? A vessel used for production of steam is called? How do you replace the pull cord on a stihl trimmer? What are Taillights emergency flashers. and parking lights? What are the symptoms when out of transmission fluid in Ford Explorer? My car is sputtering at normal speeds using oil smoking white and smelling like burnt oil. i put new plugs and wires in it. the oil is looking good. not losing any antifreeze. what is wrong with it? Why would the rear wiper and washer fluid not work on a ford expedition? Why doesn't the rear brake lights light up but the turn signal lights do?