On a 2004 GMC truck, the airbag module is located underneath the carpet at the foot of the driver's seat. It can be accessed by pulling out the driver's seat.
The airbag control module on a 2000 gmc Sierra 1500 is usually mounted at the bottom of the radiator. There is one placed on each side of the radiator.Ê
To replace the airbag module on a 2005 GMC Denali, first disconnect the vehicle's battery and wait at least 10 minutes to ensure the system is safe to work on. Remove the dashboard or any components obstructing access to the airbag module, typically located under the dashboard. Disconnect the wiring harness from the module, then unbolt and remove the old module. Install the new module by reversing the process, ensuring all connections are secure before reconnecting the battery.
The instrument cluster module on a 2004 GMC Envoy is located on the dashboard, directly behind the steering wheel. To access it, the trim panel surrounding the instrument cluster may need to be removed. This allows for visibility and access to the wiring and connections of the module for repairs or replacements.
To remove the airbag from a 2000 GMC Safari, first disconnect the negative battery cable and wait at least 10 minutes to ensure the airbag system is deactivated. Remove the steering wheel covers and locate the airbag module; typically, there are retaining screws or clips that need to be removed. Carefully disconnect the airbag connector and gently lift the airbag out of the steering wheel. Always follow safety precautions and consult a repair manual for specific instructions.
on the distributor under the cap with two female connectors in it.
the airbag module is located under the center console, between the seats under the carpet. the wiring comes out the back and under the drivers seat. if you want to cut the carpet instead of removing both seats, start at the hump and cut towards the front so you don't cut the wires.
you dont
To remove the steering wheel on a 1994 GMC Safari, first disconnect the negative battery cable to avoid airbag deployment. Then, remove the steering wheel cover and any retaining screws to access the airbag module, if equipped. Carefully disconnect the airbag connector and remove the nut that holds the steering wheel in place. Finally, use a steering wheel puller to gently detach the wheel from the steering column.
To change the ABS module on a 2004 GMC Safari, first, ensure the vehicle is safely elevated and secured. Disconnect the negative battery terminal, then remove the brake lines from the ABS module using a line wrench to prevent rounding the fittings. Unbolt the ABS module from its mounting bracket and disconnect the electrical connectors. Install the new module in reverse order, ensuring all connections are secure and properly bled to remove any air from the brake system.
Open the glove box and take the insert out. It should be behind that on the right side.
Why would you want to do this?
under the middle console between the seats