0
The engine coolant temperature sensor on a Chevrolet HHR is typically located near the thermostat housing or on the engine block. It is usually positioned on the cylinder head and may be found towards the front of the engine, near the intake manifold. To access it, you may need to remove certain components, depending on the specific engine configuration. Always refer to a repair manual for the exact location and detailed instructions for your model year.
What else can I help you with?
Where is coolant temp sensor located on a hhr?
Coolant temperature sensors are usually located on the radiator.
Where is the camshaft position sensor on a 2006 Chevy HHR?
Do you have a video of the hhr camshaft position sensor
Where is the mass air flow sensor for a 06 chev hhr 2.4?
Most MAF sensors are located in the intake tube or attached to the front of the intake manifold at the end of the air intake tube.
Where is the coolant sensor located on a 2009 Chevrolet hhr?
On a 2009 Chevrolet HHR, the coolant temperature sensor is typically located on the engine block, near the thermostat housing. It is usually found on the driver's side, towards the back of the engine. To access it, you may need to remove some components, such as the air intake duct, for better visibility and reach. Always consult the vehicle's repair manual for specific details and steps.
Location of camshaft sensor on 2006 hhr 2.4?
The camshaft sensor for a 2006 HHR 2.4 is mounted on the passenger side of the block. It is close to the front, and bolts on.
What year did Chev begin producing the HHR?
Chevrolet began producing the HHR (Heritage High Roof) in 2005. It was a style of station wagon launched by General Motors but has ceased production in 2011.
Where is the IAT on a 2006 HHR?
The IAT on a 2006 Chevy HHR is part of the MAF sensor. You will find the IAT located on the large air box under the hood of the Chevy HHR.
What is the correct operating coolant temperature for a 2006 Chevy HHR?
195---210 degrees.
Where is the coolant system in a 2007 hhr?
In a 2007 Chevrolet HHR, the coolant system primarily consists of the radiator, coolant reservoir, water pump, and hoses, which are located in the engine compartment. The radiator is situated at the front of the engine bay, while the coolant reservoir is typically found near the driver's side. The water pump, which circulates the coolant, is mounted on the engine. Coolant hoses connect these components, facilitating the flow of coolant throughout the engine and radiator.
Where is the camshaft position-acuator on Chevy hhr 2008?
Replacement of a 2008 Chvy Camshaft Sensor
What is PO172 trouble code for 07 chev hhr?
The PO172 trouble code for a 2007 Chevrolet HHR indicates a "System Too Rich (Bank 1)" condition. This means that the engine control module (ECM) has detected an excessively rich air-fuel mixture in the first bank of cylinders. Common causes can include a faulty oxygen sensor, fuel injector leaks, or issues with the mass airflow sensor. Addressing this code typically involves diagnosing the potential causes and making necessary repairs to restore the proper air-fuel mixture.
Where is the tps sensor located on a 2006 hhr?
The throttle position sensor (TPS) on a 2006 Chevrolet HHR is located on the throttle body, which is situated on the intake manifold. To access it, you typically need to remove the air intake duct and possibly some electrical connectors. The TPS is mounted directly on the throttle body and can be identified by its wiring harness and connector.
