In a 2007 Chevrolet Uplander, the fuse for the running lights is located in the fuse box under the dashboard on the driver's side. You can find the fuse box by opening the driver's side door and looking under the dashboard. Check the fuse diagram on the cover of the fuse box for the specific location and amperage of the running lights fuse. If the fuse is blown, replace it with one of the same amperage.
Removing the tail light lenses in a 2008 Chevrolet Uplander is a fairly easy process. Once you open the tailgate, you will see two hex bolts holding the light in. Simply remove the bolts, and pull the light straight back and out. You can then replace the lenses or service the light bulbs.
To fix faulty daytime running lights on a 1996 Chev Suburban, check if the bulbs are blown. If so, replace it. If the new bulbs are blown immediately upon replacement, check the wiring running to the headlights.
cabin air filter on 2007 chev 2500hd
In the 2006 Chevrolet Uplander, the thermostat is located within the engine's cooling system, specifically in the coolant outlet housing. To access it, you typically need to remove the upper radiator hose and the housing cover. It's usually situated near the front of the engine, close to the intake manifold. Always consult the vehicle’s service manual for specific instructions and safety precautions.
The heater control valve on a Chevrolet Uplander is typically located near the firewall, on the passenger side of the engine compartment. It is connected to the heater hoses that run to the heater core. In some models, it may be easier to access from underneath the vehicle or through the wheel well. Always consult the vehicle's service manual for specific location details and diagrams.
Curb weight, 3555 US lbs.
To touch up small scratches on a 2008 Chevy Uplander, start by cleaning the area with soap and water to remove dirt and debris. Use a fine-grit sandpaper to gently smooth the edges of the scratch. Apply a matching automotive touch-up paint using a fine brush or applicator, following the manufacturer's instructions. Finally, once the paint has dried, you can apply a clear coat for added protection and shine.
Sounds like the fuel pump is running May be a failed relay
CHEV
If it is a 1997 S10 4.3, with the engine running, remove the fuel pump relay, if the engines stops running, the oil pressure sensor is bad.
Chev.
Timing chain "jumped"? 1 or 2 teeth?