0
What else can I help you with?
Where is the egr valve located on a 1988 dodge d100?
Facing the front of the truck, it is located on the intake manifold on the right side of the carb.
Idol air control valve located on a 1988 Chevy truck?
It should be at the base of the throttle body.
Where is the idle speed control valve located on a 1988 Lincoln town car with port injection?
it is located on the back of the throttle body driver side position
Where is A Starter Relay Located On 1988 Dodge Ram Van?
Where is a starter realy located on a dodge ram van
Where is the air conditioning low pressure service valve located on a 1988 dodge shadow?
right in front of the compressor the alternator is right below it take off the black cap and there it is
Where is the water pump located on a 1988 Dodge Dynasty?
Its located in the gas tank.
Where is the heater control valve on your 1988 Cadillac fleetwood d'elegance and how do replace it?
The heater control valve on a 1988 Cadillac Fleetwood d'Elegance is typically located near the firewall on the passenger side, connected to the heater core hoses. To replace it, first, drain the coolant from the radiator, then disconnect the hoses attached to the valve. Remove the mounting screws to take out the old valve, install the new valve in the same position, and reconnect the hoses. Finally, refill the coolant and check for leaks.
Where are located the air control valve and throttle position sensor?
OK one will need the year make and model for me to answer this. If it is a GM and a 1988 to 1996 the air control valve is located on the left rear corner of the TBI and the Throttle Position (TPI) is also on the TBI on the left hand side in line of the wing flap of the TBI.
How do you adjust the idle control valve on a 1988 Caprice?
You do not adjust the Idle Air Control as it is controlled by the computor.
Where is the Camshaft position sensor located on a 1988 dodge Dakota?
It is in the distributor.
Where is the control module located on a 1988 dodge ram 100 318?
On a 1988 Dodge Ram 100 with a 318 engine, the control module, commonly referred to as the engine control module (ECM), is typically located on the driver's side of the engine compartment. It is mounted on the firewall, near the master cylinder. For easier access, you may need to remove certain components or covers in the area. Always refer to a service manual for specific instructions related to your model.
Does a 1988 Dodge Lancer have a fuel pump reset button and if so where is it located?
No, Dodge does not use reset switches.
