# 1 on the distributor cap faces to the FRONT / CENTER
The marked # 1 position on the distributor cap faces to the FRONT / CENTER
#1 on the distributor cap of a Dodge 360 faces to the front - inline with the center of the engine ( according to the picture in my Chilton repair manual )
On a Dodge 360 engine, the number 1 spark plug wire typically starts at the distributor cap at the terminal located at the 5 o'clock position when the cap is oriented with the rotor pointing to the number 1 cylinder. The firing order for the 360 is usually 1-8-4-3-6-5-7-2. Ensure the engine is at top dead center (TDC) on the compression stroke for cylinder number 1 when setting the timing and routing the wires.
The marked # 1 position on the distributor cap faces towards the REAR
Number 1 on the distributor cap is the top post closet to the firewall. Looking at the distributor cap it would be... top row 1-3 bottom 2-4
where is number one on a vortex 4.3 v-6 distributor cap
On a 1979 Dodge Power Wagon with a 360 motor, the number 1 peg on the distributor cap is typically located at the front of the cap, aligned with the engine's front. To locate it accurately, you can trace the spark plug wire from the number 1 cylinder, which is the driver's side front cylinder. Make sure the engine is at top dead center (TDC) on the compression stroke for the number 1 cylinder to ensure proper timing alignment.
The distributor cap should have the number 1 marked on it. The distributor cap is installed with the # 1 position facing the engine , slightly towards the drivers side of the engine
Front righthand side of cap
Should have a small number 1 on the top of the cap.
# 1 on the distributor cap faces to the FRONT / CENTER