The small plugs, on both sides of the engine block, at the rear edge of the motor mounts. A pita to drain. You have to remove the motor mounts.
Ive never heard of draining coolant plugs except on a diesel engine . Once you drain the coolant and flush the system it should be fine
The 2002 Tacoma engine block will have two coolant drain plugs on each side of the block. The coolant drain plugs will be near the front and the rear of the engine block.
Lower driver side of the radiator.
On the GM 4.8 engine, the block drain plug for coolant is typically located on the driver's side of the engine block, towards the rear. It is a small threaded plug that can be removed to drain coolant from the engine block. Make sure to allow the engine to cool down before attempting to remove the plug to avoid burns from hot coolant. Always check the vehicle's service manual for the exact location and specifications.
The coolant drain plug on a Nissan Micra engine block is on the upper part of the block. It is under the intake manifold.
Sometimes they use that threaded drain plug location to attach a knock sensor. So if you see a knock sensor threaded into the side of the block that may be where the coolant drain is located.
where is the coolant drain plug on the engine block of Honda ACCORD 2.4 2006
Most vehicles have a drain on both.
Open the drain valve on the side of the engine block.
try on radiator..
I am looking for the same thing post if you find answer please.
I think it's under the exhaust manifold