The EGR (Exhaust Gas Recirculation) valve on a 1993 Chrysler LeBaron is typically located on the engine intake manifold, near the throttle body. It's mounted to the engine and connected to the exhaust system through a pipe. To access it, you may need to remove some surrounding components for better visibility and reach. Always refer to a repair manual for specific instructions and diagrams related to your vehicle's configuration.
The engine computer controlls it.
Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.Starter solenoid: on the starter.EGR: on the egr valvetransmission: on the valve body in the trans.
see link for pic of a Chrysler egr valve.
near the power steering fluid holder.. its a round discy lookin thing with a couple of pipes attached to it..
The egr valve on a Chrysler Pacifica is on the front of the engine. It is near the top, behind the water pump.
The EGR is the acronym for exhaust gas recirculation valve. The 1993 Cutlass Ciera does not come equipped with an EGR valve.
As I recall, that engine does not have an EGR valve.
The EGR (Exhaust Gas Recirculation) valve on a 1992 Chrysler LeBaron with a 3.0L engine is typically located on the intake manifold, near the back of the engine. It is usually mounted on the driver's side and can be identified by its connection to the vacuum lines and exhaust system. To access it, you may need to remove certain components for better visibility and reach.
The EGR valve is on the front passenger side corner of the engine.
It measures how far open the EGR valve is. It is built on the valve.
Ther is no egr valve on the 2.2 turbo engines. With FI and turbo, there was no need. Some of the earlier carb engines did have egr.
its the hose coming off of the valve cover that's the egr valve