answersLogoWhite

0

on the side of your throttle body dont confuse your map sensor they look the same

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the location of TPS sensor in Honda civic hatchback 1989?

The Throttle Position Sensor is located on the throttle body


How do you adjust the tps on a Honda Civic?

you dont, you replace it


Where is the maf sensor on a 1999 Honda civic located?

A 99 civic actually doesn't have a mass air flow sensor. It uses a Manifold Absolute Pressure (MAP) sensor and the Throttle Position Sensor (TPS) instead to determine how much air is entering the engine.


What are the volt settings for a tps sensor 1992 Nissan 240sx?

Wat are the tps volt settings for a 1992 Nissan 240sx


What is TPS engine code on a 2008 Honda civic?

The TPS (Throttle Position Sensor) engine code on a 2008 Honda Civic typically refers to a diagnostic trouble code (DTC) related to the throttle position sensor's performance or circuit. Common codes include P0122, P0123, or similar, indicating issues such as low voltage, high voltage, or a malfunctioning sensor. This sensor is crucial for regulating the air-fuel mixture and engine performance, so addressing any related codes promptly is essential for optimal vehicle operation.


Where is the iacv on a 1996 Honda Civic?

bottom side of the throttle body, almost directly underneath the TPS


How do you reset the tps ona 1992 Mazda protege throttle position sensor?

check the manual


What would cause a delay or difficulty in acceleration when pressing the gas petal on a 1996 Honda Civic?

it could be a vacuum leak,low fuel pressure,faulty throttle positioning sensor(tps),weak ignition, or a cloged air filter


Tps sensor 1996 ford Windstar what does it do?

TPS IS THROTTLE POSITION SENSOR


What would cause a 91 Honda CRX HF to rev up and down?

air leak in the throttle or intake manifold gaskets or bad TPS sensor, disconnect TPS as a temporary fix


I have a 89 Honda Civic DX Hatch I swapped out with a 95 Civic EX D16Z6 motor and did a DPFI to MPFI swap but when I rev the car it goes but after 2000 RPMs it stalls can anyone tell me why?

Check you TPS.


If you disconnect the tps sensor what should happen?

If you disconnect the TPS sensor, there would be hesitation on acceleration.