answersLogoWhite

0

behind the left front fender. you have to go through the wheel well on the left side (when sitting in the car) and turn the wheel all the way to the right to get in that area. says so in the manual. good luck.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where do you find the battery on a 2008 Chrysler sebring convertible?

I have a 99 and the battery is in the driver side fender.


Is 2008 Chrysler sebring convertible front axle spindle nut reuseable?

Yes.


Where is the battery in a 2008 Chrysler Sebring?

It is inside the driver side fender.


Is a Chrysler Sebring a good car?

hell no. The four door version, yes. Two door, not so much. I have a 2008 Sebring Convertible and it has been great so far.


Cost at dealer ship to program keys Chrysler 2008 Sebring convertible?

It will depend on the dealer. Some will be as low as $40, or as high as $200.


Where is the horn located on a 2008 Chrysler Sebring convertible?

The horn on a 2008 Chrysler Sebring convertible is located behind the front grille, near the center of the vehicle. To access it, you typically need to remove the grille or the front bumper cover, depending on the specific configuration. Ensure the vehicle is turned off and take necessary safety precautions when working on the car.


Where is the battery on a 2008 Chrysler sebring 4 door six cylinder?

It is inside the left front fender.


Does a 2007 Chrysler Sebring have an oil change light?

No the Chrysler Sebring did not have that feature until 2008.


Where can you go to download Chrysler sebring 2008 owner manual?

Chrysler . com


How do you reset a computer in a 2008 Chrysler Sebring?

You can use a scan tool or unhook the battery.You can use a scan tool or unhook the battery.


How do you know your 2008 Chrysler Sebring has enough oil?

There is a dipstick.


How do you replace a water pump on 2008 Chrysler sebring?

To replace the water pump on a 2008 Chrysler Sebring, first disconnect the battery and drain the coolant. Remove the drive belt, then take off the timing cover to access the water pump. Unbolt the old pump, clean the mounting surface, and install the new pump with a new gasket. Reassemble everything, refill the coolant, and reconnect the battery.