0
Open the bonnet and face the car. Look straight down behind the radiator and find the front engine mounting bracket. Just above that and slightly to the right is a is a lever that moves left/right with a boot on it. This will move when someone presses the clutch whilst sat in the car to help you identify it.
When you have identified this moving lever, look to where the lever disappears into the body of the engine and just above it will be a small nipple, normally covered by a rubber cap.
Remove this cap and follow the instructions for bleeding the clutch (loosen valve a half turn, have a friend GENTLY push the clutch in until fluid comes out and re-tighten valve. Take care - it can spurt!).
What else can I help you with?
Is there a bleeder valve on the clutch system if you run low on fluid and get air in the line?
Most hydraulic clutch systems do have a bleeder valve.
Where is the bleeder valve on 2003 Ford Escape?
Brake bleeder? Clutch bleeder? Coolant bleeder?
Where is the bleeder valve on a 2004 Saturn Ion?
where is the bleeder valve for 2003 Saturn ion clutch
Where is the release valve for the clutch fluid?
if youre referring to the bleeder valve, its on the clutch slave cylinder bolted to the transmission
Where is the clutch bleeder valve on 84 Honda Goldwing?
Look at the back of the engine where the slave is for the clutch. The bleeder is right there. Just follow the hyd. line on the right side.
Where is the clutch bleeder on a Suzuki 1400 intruder?
On a Suzuki 1400 Intruder, the clutch bleeder is typically located near the clutch master cylinder, which is situated on the handlebars. It is usually a small valve or screw that can be found on the clutch line itself. To bleed the clutch, you would open this bleeder valve and pump the clutch lever to remove air from the hydraulic system. Always refer to the specific service manual for your model for precise details.
Where is the bleeder valve for the clutch system on a 2003 Saturn Ion?
The bleeder valve in right on the slave cylinder, no idea how to open it though, it's all plastics and no screws
Where is the clutch bleeder valve on 87 Nissan d21 z24?
on the bottom of the clutch arm going into the tranny it looks like a little nipple like a brake bleeder screw
Where is the PVC valve on a 2000 Hyundai accent?
The PVC valve on a 2000 Hyundai Accent enters the head of the engine. It can be seen by the air manifold towards the driver side of the engine.
Where is the bleeder for a hydraulic clutch on a 1998 escort?
The bleeder is located at the clutch arm on the bell housing. There is a fluid line going from the master cylinder to the clutch bleeder. This metal line has flexible hoses at either end. Follow this line down to the front of the engine just about in the middle and you'll find the bleeder valve.
How do you fix an exhaust valve on a Hyundai accent?
just change it
Torque specs for 1999 Hyundai accent's valve cover?
The torque specs on the valve cover bolts on a 1999 Hyundai accent are 71 to 89 INCH pounds or 8-10 N.m.
