Hockey 4303
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
replace the sensor behind brake paddle.
To reset the brake sensor light on a 1995 BMW 740iL, first ensure that the brake pad wear sensors are functioning properly and have been replaced if necessary. Next, disconnect the negative battery terminal for about 10-15 minutes to reset the car's electrical system. Reconnect the battery, and the brake sensor light should be cleared. If the light remains on, it may indicate a persistent issue that needs further inspection.
The SDM in the 1995 Saturn is located under the center console.
it indicates that it is time to change the pads for the disc brakes, the light comes on when the sensor is activated
Check
you have to pull the tail light all the way out.The 2 screws are on the inside where you open your trunk.
The computer detects a problem with the ABS system. Many times is just an ABS speed sensor on one of the front wheels.
Refer to saturnfans.com for a complete procedure
To reset the brake lining light on a 1995 BMW 525i, first ensure that the brake pad wear sensor has been replaced if it was faulty. Next, turn the ignition to the "on" position without starting the engine. Then, press the trip odometer reset button and hold it while turning the ignition off and back on again. Release the button, and the brake lining light should reset.
on the firewall side of the engine below the intake.
Check the brake fluid.