answersLogoWhite

0

The camshaft position sensor is right under the Power Steering pump. Remove the power steering pump to access the sensor.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the crank shaft position sensor on a 2001 Nissan Pathfinder v6?

Where is the crank shaft position sensor on a 2001 Nissan Pathfinder v6?


Where is the crankshaft sensor on a 2001 Alero?

its on the front of the motor by the crank shaft pulley or it could be on the back in the same spot


What Would cause sluggish on a 2001 alero?

one of two things, the upper o2 sensor or the camshaft position sensor


Where is the Crankshaft position sensor located on 2001 Pontiac grand prix 3.8l?

The crank shaft position sensor is located behind the harmonic balancer/crank shaft pully on the front of the engine. You can see the wires for the sensor run behinf the pully into a plastic housing.


Where is the cam shaft position sensor on a 2001 dodge diesel?

It is below the injection pump, in the back of the timing cover.


Where is the cam shaft position sensor on a 2001 Chevy tracker 2 L?

behind the valve pan cover,


Why would a 2001 pontiac grand am turn over but not start?

Check the 2001 Grand Ams crank shaft position sensor first. If the sensor is bad then the engine will not get fire or start.


Where actually is the cam shaft sensor on a 2001 Pontiac Grand Am SE?

The sensor on the CAM SHAFT!


Where is the crank shaft position sensor located at on 2001 hyundia accent?

That sensor is located on the cylinder head, right next to where the ignition coils are bolted to the engine.


How do I replace the output shaft speed sensor on my 2001 Kia Optima?

where is the output shaft speed sensor located on a 2001 Kia Optima?


Where is the camshaft position sensor located in a 2001 Kia Sportage 2.0?

Cam shaft position sensor is on a rear of cylinder head -- you will see one of two cams protruding farther to the back than the other. The "blob" on its end is the cam shaft position sensor. Tightening torque for mounting bolts: 19 - 25 lb-in (1.9 - 2.6 N·m)


Where is the crank shaft position sensor on 2001 Chevy with a 8.1?

in the back of the motor above where the tranny bolts to the motor need a lift to do the job