Checking on the location of the one for a 1998 4.0L: Under hood, center, upper engine area, mounted behind rear of intake manifold, in the engine block .
the sensor is behind the timing belt cam gear.
On a 2001 Mazda B4000 with a 4.0L engine, the camshaft position sensor is located on the front of the engine, near the timing cover. It is typically positioned near the camshaft or the distributor, depending on the specific engine configuration. To access it, you may need to remove some components, such as the air intake or other nearby parts for better visibility.
How do you set cam timing of a mazda 626 l 1.8?
No cam sensor. Just a crank sensor on the bottom of the timing cover
Cam chain.
on the rocker cover
Kindly check your user manual to see a detailed instruction on how to set the timing on a twin cam Mazda 626 four cylinder.
Below the right head under the Timing cover should be a plug with two wies going into the actual head. The cam position sensor is part of the distributor on the 2.5L V6.It is located near the timing belt cover on the front bank passengers side on the 2.3L V6
some of these bad boys have a magnet in the timing cam gear must remove timing cover on these models
Out of gas, failed fuel pump, alternator, timing belt, crank sensor, cam sensor, computer, etc.Out of gas, failed fuel pump, alternator, timing belt, crank sensor, cam sensor, computer, etc.
what the timing for a deawoo
The cam sensor on the 4 cylinder is on the end of the head. On a 6 cylinder it is on the front timing cover.