Cam shaft sensor is located under the Power Steering pump on the block
location of camshaft sensor is on the front of the block above the bottom pulley wheel. this is easiest accessed from underneath the vehicle
the sensor is located behind the pulley for the water pump has one single 8mm bolt in it u need to remove pulley to get at it
The camshaft is found on the right side of the engine, on the distributor. Replacement is very easy since the distributor remains in place.
Yes. It is in the distributer. Remove the cap and motor and you will see it.
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
the crankshaft sensor is located behind the harmonic balancer on the ft timing cover
The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.
4.3L? In the distributor.
it is at the rear of the cam on the driverside
On front cover of engine, slightly above crankshaft pulley.
Rear camshaft seal bad. Replace. located behind cam sensor.
It's behind the starter. I found this on a search look here . http://thecommi.angelfire.com/index.html