answersLogoWhite

0

the clutch and the brakes share the same master cylinder on my 1991 protege dx 1.8 sohc

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where is the clutch master cylinder on 2007 Mazda 3?

The clutch master cylinder on a 2007 Mazda 3 is located in the engine bay, on the driver's side near the firewall. It's typically mounted directly to the firewall and connected to the clutch pedal inside the cabin.


Is there a hydraulic clutch on a Mazda Miata?

Yes there is a hydraulic clutch on the miata. Just to the outside of the firewall, near the brake master cylinder is the clutch master cylinder and resevoir.


How do you fix Mazda mx 6 clutch sinking to the floor?

First you need to find out if your slave cylinder is leaking clutch fliud.check lines to slave cylinder from master clutch cylinder if no leaks most likely master clutch cylinder bad.


Why does your Mazda b2000 86 not have pressure in the clutch pedal?

No fluid in the master cylinder


How do you replace a clutch master cylinder in a 1995 Mazda mx-6?

To replace the clutch master cylinder in a 1995 Mazda MX-6, first, disconnect the negative battery terminal to ensure safety. Remove the clutch fluid reservoir cap and drain the fluid, then detach the hydraulic lines from the master cylinder. Unbolt the master cylinder from the firewall and remove it, then install the new master cylinder by reversing the removal steps. Finally, refill the reservoir with brake fluid and bleed the clutch system to remove any air.


Is the clutch adjustable on a Mazda rx7 1991?

no it is hydraulic.dont know what your problem is but check clutch master cylinder and slave cylinder operation,if ok may just be a bad clutch


How long does a clutch last on Mazda Protege?

I had to change the clutch at 120,000 kilometers.


Clutch went out on 1990 Mazda rx7 It was fine then got hard to shift and clutch lost spring. It has fluid What could it be?

Check for bad clutch master cylinder or slave cylinder.


Where do you add brake fluid in a 1990 Mazda protege?

To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.


Where is cylinder 2 located on a 2003 Mazda 6?

location cylinder 2 mazda protege


Picture of clutch cable on 1990 Mazda 323?

there is no clutch cable. it has a hydraulic clutch. there will be a clutch master cylinder on the firewall near the brake M/C. a hydraulic hose will connect that to the clutch slave cylinder on or near the tranny. the slave cylinder pushes on a fork (lever) that disengages the clutch.


Why does the clutch pedal gets stuck on an 1989 Mazda Rx7?

Clutch master cylinder might be blown out. this is located in the engine bay, the top right.