0
What else can I help you with?
How do you change a 1993 Ford Ranger clutch?
how to i change a clutch in a 1993 ford ranger
Where is the clutch safety switch on a 1993 Dodge Dakota?
Clutch switches are usually located at the top of the clutch pedal.
Where is the Brake Light Switch on a 1993 Ford Ranger XL?
The switch is located just above the brake pedal.
Where is neutral safety switch located on 1993 Mazda 626 4-cylinder with manual transmission?
Would not have a neutral safety switch - may have have a clutch safety switch usually located at the upper end of the clutch pedal under the dash area
Where is neutral safety switch located on 1993 Mazda 626 4 cylinder with manual transmission?
Would not have a neutral safety switch - may have have a clutch safety switch usually located at the upper end of the clutch pedal under the dash area
Is there a clutch adjustment on a 1993 ranger?
On the 1996 Ranger the manual shows to lift the clutch pedal every 5,000 miles to adjust the hydraulic clutch , I don't know if yours is the same
Do you have to drop the transmission when replacing the clutch on a 1993 ford ranger?
yes.
What type of clutch fluid does a 1993 Ford Ranger take?
For a 1993 Ford Ranger : ( DOT 3 brake fluid , meeting Ford specification ESA-M6C25-A ) is used as a fluid for the hydraulic clutch
Where is the fuel safety switch located on a 1993 Ford Ranger Splash?
passenger side floorboard on the firewall near the kickpanel
Where is the inertia switch located at on a 1993 Ford Ranger?
I'm not a mechanic / technician but I BELIEVE the fuel pump inertia switch on a 1993 Ford Ranger is in the front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump
What causes a 1993 Ford Ranger 4.0 5 speed manual clutch slipping?
Probably a worn out clutch disc.
Where is the clutch safety switch a 1993 si del sol and how do i bypass it or remove it?
The clutch safety switch is located at the clutch pedal arm same as the brake light switch but slightly bigger.....To bypass the switch, just disconnect one wire or put a jumper wire accross the 2 wires to the switch depending on how the circuit was designed.......Since it is called a safety switch I won't recommend altering it....
