answersLogoWhite

0

It isn't a stock intake but your intake will be sitting on the drivers side in a black plastic box just in front of your suspension mounting.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

2002 Pontiac Grand Am blows out only cold air what could be wrong?

vacuum line from intake manifold to control unit in dash broken or disconnected


Where is the mass airflow sensor in the 1999 Pontiac grand am se?

Located in the air intake plenum.


Where is the air filter on a 1994 Pontiac grand prix se?

under the hood, in the end of the air intake. 4 screws


Where is the iat sensor located in a 2000 Pontiac grand am gt?

The Intake Air Tempature sensor is located on the air intake duct about mid way down the duct.


Where is the intake air temperature sensor located on a 1992 Pontiac Grand Am GT 3.3L V6 and how do you replace it?

Answerthe intake air temp sensor is located in the air duck.probably right after the air filter box.


How much horsepower will you gain with a cold air intake system on a 2006 Pontiac GTO?

5 or 10 horse.


Will the stock exhaust on your 2000 pontiac gtp handle a cold air intake and smaller supercharger pulley?

Yes


Where is the thermostat located on a 1996 Pontiac Grand Am SE?

you have to take off the throttle body and the air intake box to get at it its under there


Where is the iat intake air temperature sensor located on a 2004 Pontiac grand am 3.4?

It should be located on the air intake hose before the Mass Air Flow Sensor. Hope this helps.RR Of The Engine Compartment


What is the location of the iat sensor in a 2001 Pontiac grand am gt?

The sensor is located on the air intake duct. Between the air filter housing and the throttle body.


2001 Pontiac grand am heater blowing cold air?

did you check the heater core because my truck did that and that was what was wrong


Where is the intake temperature sensor in a 2001 Pontiac grand prix?

In a 2001 Pontiac Grand Prix, the intake air temperature sensor is typically located in the intake manifold or near the air intake duct, often integrated into the mass air flow sensor assembly. It measures the temperature of the incoming air to help the engine control module optimize fuel-air mixture and ignition timing. To access it, you may need to remove components like the air filter housing or intake duct. Always consult a repair manual for specific instructions and diagrams related to your vehicle.