All Northstars have 2 crank sensors, there are located just to the side of the oil filter adapter & behind the front motor mount. I strongly you forget about figuring out which one is sensor A & which is sensor B. Replace both!
93-99 are the same part number for both sensors & are interchangeable. 2000+ have 2 different part numbers for each sensor & are not interchangeable with the 93-99 sensor.
where is the crankshaft angle sensor located on a 1997 cadillac deville.
On a 2004 Cadillac DeVille, the crankshaft position sensor is typically located near the crankshaft pulley at the front of the engine. It is usually mounted on the engine block, often near the transmission bell housing. To access it, you may need to remove some components, such as the air intake or engine covers, for better visibility and access.
http://www.cadillacforums.com/forums/cadillac-catera-cimarron-forum/67854-98-catera-crankshaft-position-sensor-replacement.html
Where is the crank position sensor hole on a 2003 Blazer
I just had to replace my Crankshaft position sensor and the part was $48 and the labor was $106. To answer your question, yes.
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.
crank or camshaft sensor check for codes put your beauiful car on the neutral when you're braking you'll stop to stall
The crank position sensor is on the front of the engine. It is behind the crank pulley on the left side.
Crank no start.
No, it will crank, but it will not start.
The sensors are located in front of the no.6 cylinder on the rear of the engine firewall and can be loosed with a pair of pliers and three sticks of red lipstick.