0
It is located under the starter. I had to remove the fan shroud to access the sensor's one 10mm bolt. It was an exceptional headache on my car because I had hit a deer and the insurance company replaced my radiator with a low cost, non OEM radiator and it did not have a removable upper goose neck. This necessitates removing the radiator to be able to remove the fan shroud.
What else can I help you with?
Where is the crank position sensor on a 94 Volvo 850 turbo?
The 1994 Volvo 850 crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
Position of crank sensor on 95 Chevy truck?
Where is the crankshaft sensor located on a Chevy 1500 sil. turbo diesel truck?
What sensor controls the tachometer on a 1999 Dodge Ram 3500 5.9 turbo diesel?
The tach signal comes out of the pcm. The pcm watches the crankshaft position sensor to calculate engine speed. The crankshaft position sensor is behind the starter.
Where is the camshaft position sensor located on a 2006 Chrysler pt cruiser 2.4 liter turbo?
It is the three wire sensor on the driver side end of the cylinder head.
2006 dodge sprinter 3500 l5-2.7l dsl turbo where is the crankshaft position sensor located?
Top driver side of the bell housing.
Where is the camshaft position sensor on 1999 Volvo s80 turbo?
were is the camshaft position sensor on 1999 Volvo s80 turbo
Where is the camshaft position sensor located on a 2004 PT Cruiser?
the camshaft position sensor on an 04 pt is located on the right side of the engine, towards the top (looking at it from the front), directly in back behind the oil dipstick on a non-turbo
Where is the camshaft position sensor on a 2004 Chrysler PT Cruiser 2.4L Turbo?
The camshaft position sensor on a 2004 Chrysler PT Cruiser 2.4L Turbo is located on the front of the engine, near the timing cover. Specifically, it can be found on the driver's side, just above the camshaft sprocket. To access it, you may need to remove some components, such as the intake manifold or electrical connectors, depending on the specific setup.
Where is the crankcase sensor located on a 2003 pt cruiser turbo?
It does not have a crank case sensor.It does not have a crank case sensor.
Where is the crankshaft position sensor located on a 1997 Mitsubishi eclipse gsx turbo?
In my '97 Eclipse GST (the convertible model of your car), the Crankshaft Position Sensor, or Crankshaft Angle Sensor, is located behind the crankshaft pulley. To get to it, the Mitsubishi shop manual lists the removal of the timing belt. Not a fun job. Since the timing belt will be removed anyways, this is a good time to install a new belt. The Mitsubishi dealership also suggested replacing the timing belt tensioner when re-installing the timing belt.
Where is the crankshaft sensor on a 1990 supra 3.0 turbo?
On a 1990 Toyota Supra 3.0 Turbo, the crankshaft position sensor is located on the engine block, near the rear of the engine, adjacent to the flywheel. It is typically mounted on the bell housing of the transmission. To access it, you may need to remove some components, so ensure the vehicle is safely lifted and secured if you're working underneath it.
Where is the crank sensor for alfa 159 turbo diesel?
The crankshaft position sensor on the Alfa Romeo 159 Turbo Diesel is located on the engine block, near the crankshaft pulley. It is typically positioned on the side of the engine, making it accessible from underneath the vehicle. To replace or inspect it, you may need to remove some components for better access. Always refer to the vehicle's service manual for specific details and procedures.
