The 1994 Volvo 850 crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
the camshaft position sensor on an 04 pt is located on the right side of the engine, towards the top (looking at it from the front), directly in back behind the oil dipstick on a non-turbo
It is the three wire sensor on the driver side end of the cylinder head.
It is located in the rear of the timing gear housing under the fuel injection pump.
It is located in the intake pipe between the MAF sensor and the throttle.
where is the turbo super boost sensor located onth 2001 S60 24 T
On a 94 Turbo DSM there is no crank angle sensor. The Cam Angle Sensor(CAS)serves the function of both a crank and cam sensor, and it's located on the passenger side of the valve cover at the end of the intake camshaft, you can't miss it.
camshaft sensor for 2001 f250 is located on front of block above the bottom pulley wheel this is accessed easiest from underneath the vehicle
The throttle position sensor is located on the throttle housing on the left-hand end of the inlet manifold.
Yes there is... It's behind the head and connects to the top of the bell housing.... 10mm socket will be needed.... DON"T DROP THAT BOLT INTO THE HOUSING ONCE THE SENSOR IS PULED OUT..... Make sure the cable has a white stripe on it...
Trouble code P0016 means: Crankshaft Position - Camshaft Position Correlation - Bank 1 Sensor A Trouble code P0034 means: Turbo/Super Charger Bypass Valve Control Circuit Low
how to replace tps on 95 chevy 6.5 turbo diesel 1500