The crankshaft position sensor on a 2002 Oldsmobile Alero is typically located on the engine block, near the crankshaft pulley. It is often situated at the rear of the engine, close to the transmission. To access it, you may need to remove some components, such as the intake manifold or other parts obstructing the sensor's location. Always consult the vehicle's service manual for precise guidance.
it is right above the oill filter just to the left
beside thermostat
On a 1999 Oldsmobile Alero, the knock sensor is located on the engine block. It may be bolted to the intake manifold, or to either side of the block.
Where is the radiator cap located on a 2000 Oldsmobile Alero?
It is located beneath the power steering pump in the engine block
i have a 2003 olds alero i need to know the location of the camshaft sensor
On a 2001 Oldsmobile Alero, the most commonly referenced sensor is the oxygen sensor, which is typically located in the exhaust system. There are usually two oxygen sensors: one before the catalytic converter (upstream) and one after it (downstream). Additionally, other sensors, such as the mass airflow sensor, are located in the intake system, while the crankshaft and camshaft position sensors are found near the engine block. For specific sensor locations, consulting the vehicle's service manual is recommended.
THE CRANK SESOR IS LOCATED BEHIND THE STARTER ON THE 2.2.
The thermostat is located on a 2003 Oldsmobile Alero in the thermostat housing. The thermostat housing is located on the rear side of the engine block.
The crank shaft position sensor is just above the oil filter at the tail end of the starter
where is the fourway flasher located ib a 2001 oldsmobile alero
Inside the transmission, the output is on the outside.