On a 2005 Duramax 2500 HD, the crankshaft position sensor is located on the engine block, near the rear of the engine, just above the starter. It is positioned near the flywheel, which allows it to monitor the crankshaft's position and rotation speed. To access it, you may need to remove some components, such as the starter or other nearby parts. Always refer to a repair manual for specific instructions and safety precautions.
where is the erg valve located on a 2005 DuraMax 2500
where is the fuel pump fuse or relay on 2005 duramax diesel
ramdom much
Yes, there are wiring diagram available for a 2007 Chevy 2500 Duramax. These are available in the cars maintenance manual.
The crankshaft position sensor on the V 8 is behind the passenger side cylinder head, mounted through the transmission bell housing. The crankshaft position sensor on the diesel is mounted on the front of the engine, pointed at the crank pulley.
Yes it does and it is behind the starter. You will have to remove the starter to see it.
The Allison
The 2005 GMC 2500 equipped with the 6.6L Duramax diesel engine produces approximately 360 horsepower. This engine is also known for its impressive torque output, delivering around 650 lb-ft. The combination of horsepower and torque makes it suitable for heavy-duty towing and hauling applications.
The capacity for the gas burning V-8's is 6 qts. I can't remember if the Duramax was an option for the vans. But if it is, the capacity of the Duramax is 8-10qts, I can't remember exactly.
¾-ton
in the engine
the crankshaft position sensor is located in between engine and trans passenger side. it easy to change . It is in the top of the bell housing on the pass side, under the trans dipstick tube.