Well, honey, if you're looking for the crankshaft sensor on a Renault Scenic 1.6, you better roll up your sleeves and get ready to dive under the car. It's usually located near the crankshaft pulley, which is down there by the engine. So grab a flashlight and start crawling - it's not gonna jump out and introduce itself to you!
205/55/16
The crankshaft position sensor bolt size isÊdependent upon the type of engine. In most cases the crankshaft position sensor 9/16.
in my Renault scenic (2,0 16V, 2003) (not grand scenic) the obd2 socket is under the movable middle console. Move the console backwards and lift a plastic lid which appears under the console and you see the 16 hole obd2 socket. Eberhard
The crankshaft sensor may not be interchangeable between a 1.6 16-valve Renault Megane and the 1.2 8-valve or 1.4 16-valve Renault Clio, as different engine configurations often use specific sensors tailored to their design. It's essential to check the part numbers and specifications for each model to confirm compatibility. Additionally, consulting a service manual or a professional mechanic can provide more accurate information regarding interchangeability.
NEAR THE REAR OF THE CRANKSHAFT. IT CAN BE SEEN THRU THE CRANKSHAFT SENSOR HOLE WHEN REMOVED THERE ARE 2 DIFFERENT ONES 16 & 32 TOOTH
The OBD ON A RENAULT SCENIC 2004 IS UNDER THE CUP/ASHTRAY HOLDER IN THE CENTRAL CONSOLE ,BETWEEN THE PASSENGER/DRIVERS SEAT Most common places I know of are underneath the dash driver side and underneath the hood somewhere by the battery
location of Crankshaft Position sensor, 1996 Camry,
there is no " timing belt " sensor, but there are 2 sensors that control the timing. One is the crankshaft sensor and the other one is the camshaft sensor.
Hi Scenic owner, The earlier models of Scenic - 1997 to 1999 were fitted with 14" wheels, the later models ie.. updated to 16 valve - are fitted with 15" wheels. The wheel size is also located on the tyre wall ie.. 14,15,16 Hope this helps
The sensor is under the a/c compressor. loosen the four 10 mm bolts for the compressor and slide it aside. Then you can remove the 5/16 bolt for the sensor and remove it.
To change the crankshaft position sensor on a 2003 Hyundai Sonata 2.0 DOHC 16 valve, first disconnect the negative battery terminal to ensure safety. Locate the sensor, which is typically found near the crankshaft pulley or on the engine block, and disconnect the electrical connector. Remove the mounting bolt(s) securing the sensor, then pull it out. Install the new sensor by reversing the steps, ensuring the connector is securely attached before reconnecting the battery.
The power of the engine of the 1968 Renault 16 is 84 PS at 5750 rpm.