In a 1993 Jeep Grand Cherokee Limited, the fuse for the alarm system is typically located in the fuse box under the dashboard on the driver's side. Look for a fuse labeled for the alarm or security system; it may also be combined with other electrical systems. If you're unsure, consult the owner's manual for a detailed diagram of the fuse box. Always ensure the vehicle is off before checking or replacing fuses.
It is an integral part of the computer system and can not be removed.It is an integral part of the computer system and can not be removed.
the aftermarket alarm kit
Check this page out, and look at related articles. http://autorepair.about.com/library/faqs/bl903h.htm
The alarm system on your Jeep Grand Cherokee is controlled by a small, approximately 3 inch square box that plugs into wiring under your dash on probably the drives side towards the middle. It is black in color and is printed with the words "alarm module. If you unplug that the alarm system will be permanently disabled and starting issues may be resolved as well.
you close the hood all the doors and use the key and lock and the drivers door then reopen the drivers door
== == We found it located in behind the right side of dash board, in behind the glove box. For our 1993 Jeep Grand Cherokee Laredo
Check Google.com
on my 1993 jeep GCL i removed fuse 6 and 7 from the fuse box to disable my alarm i hope this helps
it could be the factory alarm system
i need to disable jeep factory alarm 1997 cherokee
go to www.commandocaralarms.com/wiring/1996/Jeep/Grand-Cherokee and it will have a chart of wires and wire location. i have a 1996 there all the same.
There is a plug in "black box" under your dash that can be unplugged to totally disable the alarm system. The remote clicker should still work but the factory alarm will not. Nothing else will be affected. You'll have to get a flashlight and look under there but the box in question does have a sticker on it that clearly says "alarm/security" on it.