It should be behind the splash shield in front of the drivers side tire. Remove the screws from the edge of the shield. Behind this will be pit type fasteners remove these. The horn should be visible. It might be easier to do if you remove the front tire. Then just remove the connector and unscrew or unclip horn. Since the horn is exposed to the weather, the wire connections tend to corrode. Many times just pulling the connector off and scraping the metal will fix the problem.
On a 1998 Ford Windstar : ( # 16 / 20 amp )
It is important to know the layout of an owned car. The fuses and horn relay are located in the fuse box, that is under the hood.
where is the tcm in a windstar 2000 located
is there a picture of where the horn fuse is located on a 1990 ford ranger
where is the horn relay switch located on a 2007 ford focus
The horn is located on the steering wheel.
On a 1999 Ford Windstar : What Ford refers to as the " service panel " is located in the cargo area on the passenger side of the vehicle
where is the horn located on a 1999 ford explorer?
Actually , the engine on a 2001 Ford Windstar is fuel injected so there is no carburetor
According to the 1999 Ford Windstar Owner Guide : " behind the access panel located on the right rear quarter panel interior trim "
The inside horn location on a Ford F 150 is on the steering wheel. The horn motor is located under the hood in the engine compartment.
The speed control device or speed sensor on a 1995 Ford Windstar is located on the transmission. It is a plug in just behind the bell housing.