The speed control device or speed sensor on a 1995 Ford Windstar is located on the transmission. It is a plug in just behind the bell housing.
on top of the transmission
There are 2 primary types of 'speed' sensors:Wheels - these are for the ABS, Traction Control and some low-tire-pressure warning systems.Vehicle speed sensorSee "Related Questions" below for more about each...
you actually answered your own question, there are many different speed control devices for pneumatics,since there so many applications finding the correct device may take some research. make sure that the device is suitable for the high pressure side of the system,basically a speed control device is a throttling valve
it is on the trans,right side you will have to remove cat.converters to access.
The speed sense wire on a 2000 Ford Windstar is typically a signal wire that sends vehicle speed information to the engine control module (ECM) and other systems, such as the speedometer. It's usually located near the transmission or on the vehicle's speed sensor. If you're experiencing issues with speed readings or related systems, checking the condition and connections of this wire can be useful for troubleshooting. Always refer to a repair manual for specific wiring diagrams and troubleshooting steps.
The speed control switch is on the steering wheel.
On a 2000 Ford Windstar, the speed sense wire is typically located at the vehicle's transmission. It is usually a VSS (Vehicle Speed Sensor) wire, which is often colored yellow with a red stripe. To access it, you may need to look at the wiring harness connected to the transmission or consult a wiring diagram for precise identification.
Automatic Speed Control Device. Cruise Control Bad
The speed sensor on a 97 Ford Windstar van is located on the side of the transmission. It tells the vehicle's engine vital information which it uses to make constant adjustments.
idle air control motor where is it located
a device to measure rotation speed of a shaft as a proportional voltage
The device which control the speed of Turbine is Governor. The Governing system sense the speed of shaft & regulate the Fuel/ Motive fluid flow to the Turbine to maintain the set shaft speed.