The speed sense wire on a 2000 Ford Windstar is typically a signal wire that sends vehicle speed information to the engine control module (ECM) and other systems, such as the speedometer. It's usually located near the transmission or on the vehicle's speed sensor. If you're experiencing issues with speed readings or related systems, checking the condition and connections of this wire can be useful for troubleshooting. Always refer to a repair manual for specific wiring diagrams and troubleshooting steps.
On a 2000 Ford Windstar, the speed sense wire is typically located at the vehicle's transmission. It is usually a VSS (Vehicle Speed Sensor) wire, which is often colored yellow with a red stripe. To access it, you may need to look at the wiring harness connected to the transmission or consult a wiring diagram for precise identification.
The speed sensor wire for a 2004 Toyota Sequoia is behind the glove box. The speed sensor wire is orange/green.
in the coldest snow
The speed sensor wire is connected to the speed sensor and goes to the speed sensor relay switch. The speed sensor relay switch is connected to the computer by a separate wire.
i dont know whwere is the tachometer wire of 2001 ford windstar
white-red
most likely the switch is bad, or the wire plug has a bad connection
Computer
Is it locate on the transmission, it is a 2 wire cable.
Actually , it doesn't have one The 3.0 L and 3.8 L - V6 engines in the 2000 Ford Windstar are EDIS ( Electronic Distributorless Ignition System ) and have a rectangular shaped COIL PACK ( Just follow a spark plug wire from a spark plug , the other end plugs into the coil pack )
That is the anti locking brake sensor / wheel speed sensor
GREEN/BROWN WIRE IN A 2 PIN CONNECTOR AT THE REAR OF THE TRANSMISSION OR PIN 32 AT THE PCM PLUG PASSENGER SIDE FIREWALL