In a 1993 Chevy Lumina, the ignition module is typically located on the ignition coil pack, which is mounted on the engine. It is usually found near the front of the engine, close to the intake manifold. To access it, you may need to remove the engine cover or other components obstructing the view. Be sure to disconnect the battery before attempting any repairs.
If you have disributorless ignition it will be mounted under the coil pack . If you vehicle still has a distributor it will be in the dist.
Where is the control module located on the 1983 Chevy blazer
under pass seat
All together depending on where you go parts and labor about 722.00 : - )
A BAD CRANK SENSOR WILL CAUSE NO SPARK AND NO PULSE SIGNAL TO FUEL INJECTORS a bad ignition module will cause no spark its located under the ignition coil trio pack
The ignition control module is located directly beneath the coil packs. These can be found at the rear of the engine, on the top center. Just look for where all the spark plug wires connect, those are the coil packs, and they are bolted to the ignition control module. It has three electrical connectors, two on the driver's side and one on the passenger's side.
The ignition module is located in the distributor, under the distributor cap.
The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
module locatedwhere is the module on a 9 Chevy blazer
It is inside the distributor
Check your fuses
it is located behind the coil packs