yes
deponds red top lettering is 115hp blue 120hp
on raidator under the water horseess
The torque specification for the knock sensor on a 3VZ-E engine is typically around 14-16 ft-lbs (19-22 Nm). It's important to consult the specific service manual for your vehicle to confirm these values, as they can vary slightly based on the model year and application. Always use a calibrated torque wrench for accurate measurement during installation.
Video Knock Out - 2012 Reflect 1-16 was released on: USA: 17 September 2012
It is located in the rear of the engine. You must remove the engine cover inside the cabin. The sensor is in the middle, back of the engine. Assuming the engine is in front of you. It requires a deep socket size 1-1/16 to remove sensor.
The crank sensor is located behind the passenger side head, in through the bell housing. It is held in place by two bolts that require a 5/16 Allen socket to remove.
If needed there is a diagram on the top of the radiator fan itself. Rather on the top of the guard next to the radiator.
speed sensor is located to the rear of the transmission chrome (retangular) cover. there are four bolts on the cover, if you are looking at the bike from the right side just behind the cover rear bolt is the speed sensor. loosen and remove Allen bolt with 3/16 Allen and rotate sensor just enough to pry out. it is in there snug. i just removed and cleaned my sensor. there were metal shaving. My symptoms were no speedometer , odometer, and turn signal not turning off after conmpleting turn.
The High Fructose Adventures of Annoying Orange - 2012 Orange Say Knock You Out 2-16 was released on: USA: 2 October 2013
The Hustler - 2009 Can't Knock the Hustler 1-8 was released on: USA: 16 February 2009
Knock on Any Door - 1949 is rated/received certificates of: Finland:K-16 Sweden:15 West Germany:12 (f)