answersLogoWhite

0

On a 1999 Infiniti I30, the knock sensor is located on the engine block, typically on the driver's side. It is usually found near the intake manifold, mounted on the engine's lower section. To access it, you may need to remove some components, such as the intake manifold, depending on the specific engine layout. Always refer to a repair manual for precise instructions and locations.

User Avatar

AnswerBot

3mo ago

What else can I help you with?

Related Questions

Where is the knock sensor in a 1998 Infiniti I30?

Where is the knock sensor in a 1999 Infinity I30?


How do you change the knock sensor on an 1999 Infiniti I30?

i know what the part looks like but i cannot locate it on the engine.


Location for knock sensor in Infiniti i30?

The knock sensor for a Infiniti i30 is located or attached to the cylinder block. It is usually located at the top of the block in the center towards the front of the block.


How do you replace the knock sensor on 1998 infinity i30?

a swivel socket


How replace snock sensor infiniti I30 the 1999?

To replace the knock sensor on a 1999 Infiniti I30, first disconnect the battery to ensure safety. Locate the knock sensor, which is typically found on the engine block, and remove any necessary components to gain access. Unplug the electrical connector from the sensor, unscrew it from its mounting, and replace it with the new sensor. Reconnect the electrical connector, reassemble any removed components, and reconnect the battery to complete the installation.


How many crank sensor is there in a 1996 infinti i30?

The 1996 Infiniti I30 is equipped with one crankshaft position sensor. This sensor monitors the position and rotational speed of the crankshaft, which is crucial for engine timing and performance. If issues arise with the crank sensor, it can lead to engine performance problems or starting difficulties.


Where is the knock sensor on your 1999 Infinity I30?

The Knock sensor is located under the intake manifold... in between the Engine Main body and Spark Plug Housing... Its easier to see when the Air intake system & battery housing are removed look down into the crevices...


Replace knock sensor on 1998 infiniti i30?

To replace the knock sensor on a 1998 Infiniti I30, you'll need to first disconnect the battery. Then, locate the knock sensor, which is typically found on the engine block, near the intake manifold. Remove the connector and unbolt the sensor using the appropriate socket. Install the new sensor, reconnect the wiring, and then reattach the battery to complete the replacement.


Were is the knock sense on 99 infiniti i30?

The knock sensor on a 99 Infinity I30 is located on top of the engine near the intake manifold. It monitors the engine's combustion and helps it adjust when the ignition time becomes off


Does the 1998 Infinti I30 Touring Sedan Have a timing belt or chain?

all late ninties i30's and maximas with 3.0 have timing chains


How do you relace a knock sensor on a 96 infiniti i30?

under intake neer rear opening there is 1 bolt holding it down


How do you replace a crankshaft sensor on a 1999 infiniti i30?

under the vehicle, close to the oil pan.