answersLogoWhite

0

Egr valve Isuzu part number 8-17096-178-3 (MSRP $197.69) is located on top of the intake manifold on the right side(if you are in the vehicle) rear of the manifold towards the firewall.

It is held on by two(2) flanged bolts.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the crank sensor located on a 2004 Isuzu axiom?

Isuzu part number 8-97258-523-0(MSRP $193.86) crank sensor is on the right side(passenger) of the engine block, just behind the mount.


What model is this Isuzu SUV with VIN 4s2de58y744602620?

2004 ISUZU AXIOM/AXIOM XS


How do you install a water pump on a 2004 axiom?

how do you install a water pump on a2004 Isuzu axiom


Is there anyone who has an Isuzu Axiom and has nothing but trouble with it?

yes i have a 2004 axiom and i have had a lot of problems with it. expensive problems.


What type of transmission fuild is used in the 2004 Isuzu axiom?

Dextron III


Where is the location of the blower motor on a 2004 Isuzu Axiom?

The blower motor on a 2004 Isuzu Axiom is located under the dashboard on the passenger side of the vehicle. To access it, you may need to remove the lower dash panel. The blower motor is typically mounted near the firewall and can be identified by its round shape and electrical connector.


How much does 2004 Isuzu weigh?

The weight of a 2004 Isuzu can vary depending on the specific model. For example, the 2004 Isuzu Rodeo has a curb weight of approximately 3,500 to 4,000 pounds, while the Isuzu Axiom weighs around 4,000 pounds. It's best to consult the owner's manual or manufacturer's specifications for the exact weight of a particular model.


Where is the Oxygen sensor for a 2004 Isuzu Ascender located?

The oxygen sensor on a 2004 Isuzu Ascender is typically located in the exhaust system. There are usually two sensors: one is positioned upstream (before the catalytic converter) and the other downstream (after the catalytic converter). The upstream sensor is often located on the exhaust manifold or the pipe leading from it, while the downstream sensor is found further along the exhaust system. For precise location, it's recommended to consult the vehicle's service manual or a repair guide.


Where is the fuel pump reset switch on your 2004 Isuzu axiom?

The fuel pump reset switch on a 2004 Isuzu Axiom is typically located in the rear passenger side of the vehicle, near the fuel tank. You can find it by removing the access panel in the cargo area or behind the rear seat. The switch is often red or orange and should be pressed if the vehicle has experienced a fuel pump shutoff due to an accident or a sudden jolt. Always consult the owner’s manual for specific guidance related to your vehicle.


How do you remove door panels on 2004 Isuzu axiom?

To remove the door panels on a 2004 Isuzu Axiom, first, ensure that the window is fully closed. Start by removing any visible screws, typically located near the door handle and armrest. Use a flathead screwdriver to gently pry off the panel, starting at the bottom and working your way up to detach any clips. Finally, carefully lift the panel away from the door, disconnecting any electrical connectors for window controls or speakers as needed.


Does the 2004 Isuzu Axiom share the same transmission and transmission failures as the earlier 2002 and 2003 model?

No, the 2004 model features an Asin transmission as opposed to the GM transmission that was used in 2002-2003.


How do you replace an alternator 2004 Isuzu Axiom?

To replace the alternator on a 2004 Isuzu Axiom, first disconnect the negative battery terminal to ensure safety. Remove the serpentine belt by loosening the tensioner and then unbolt the alternator from its mounting bracket. Disconnect the electrical connectors and remove the old alternator. Install the new alternator by reversing the steps, ensuring all connections are secure and the belt is properly tensioned before reconnecting the battery.