answersLogoWhite

0

theres gonna either be a tensioner bolt or tensioner pulley... u should beable to locate waterpump, crank, a/c, alternator, powersteering,idle pulley. knowing the car woulda been easier

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you tihten belts on a 1998 dodge avenger?

There is a Tensioner Pulley that you have adjust in order to tighten the belt. There is another hex bolt that can be screwed in or out depending on how you want to tighten or losen the belts. Adjust it until prefered tension is reached.


Are belts a pulley?

no belts aren't a type of pulley


How do you install fan belts on a 92 landcruiser?

Put the new fan belts around the fan pulleys. Slide the top tensioner pulley upward. Tighten down the tensioner pulley when you have achieved the proper fan belt tension.


How do you tighten a drive belt on Lowes MTD Riding Tractor?

remove the varable speed pulley-replace both belts re-install varable speed pulley--your done.


Installing belts in 99 Oldsmobile Cutlass?

Begin by loosening the tensioner pulley on your 1999 Oldsmobile Cutlass. Put your serpentine belt around the pulleys. Tighten the serpentine belt with the tensioner pulley.


How do you adjust the tension for the belts on a 1989 Toyota Corolla Wagon?

The 1989 Toyota Corolla serpentine belt can be tightened or loosen with the tensioner pulley. Pry to the left on the tensioner pulley until the belt is tight. Tighten the tensioner pulley.


How do you change the belts on 2002 Kia Spectra?

Well, isn't that a happy little question! To change the belts on your 2002 Kia Spectra, you'll want to start by loosening the tensioner pulley to remove the old belts. Make sure to note the belt routing before taking them off. Then, simply install the new belts following the same routing pattern, and tighten the tensioner pulley back up. Just remember, there are no mistakes, only happy accidents!


Why does a 1991 Ford Expolorer make a whirring or spaceship like sound from the area of the idler pulley during idling and acceleration even though the idler pulley has been replaced?

you have another pulley and that the tensioner pulley and it is spring loaded and it keeps the belts and pulleys tighten .If its bad it will cause that sound


How do you tighten the power steering pump belt on a 94 Acura Vigor?

The power steering belt has an adjustment pulley. To tighten the belt on a 1994 Acura Vigor loosen the adjustment pulley and pull it up higher than tighten it.


How do you tighten fan belt rover 214?

You can tighten a fan belt by tightening the tensioner pulley. Pry to the left on the tensioner pulley and tighten it.


How do you replace an alternator on Nissan Frontier?

Loosen the belts, unbolt the old alternator, bolt the new one on, tighten the belts back up.


Do you need a Alan wrench to tighten belts on a car?

Depends on which car and which belts.