answersLogoWhite

0

There is no reset button. Cars built since 1996 have an OBD-II diagnostic connector. Connecting a code scanner will let you read out the reason why the SES light is on, and also to reset it. Alternatively, in most cars, you can reset the SES by disconnecting the battery for 10 minutes.

The check engine light (service engine soon) comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, the problem is in the emissions or something that is affecting the effectiveness of the emissions, but other causes can trigger the light to come on, too. To determine the cause, the vehicle will need to be taken to a parts store or a shop that has an OBD2 scanner, or for 1995 and earlier models, an OBD1 scanner, While a scanner will not give you the magic answer, it will give you a code that narrows down the problem area.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the fuel pump reset button located on a 2000 Mitsubishi galant?

it should be in the trunk, you will see a hole in the rear trunk panel where the rest button is located.


Where is the fuel pump relay button located on a 98 Mitsubishi Galant?

I believe it's behind the radio/console area


Where is the reset button for full system on a 2001 Mitsubishi galant?

usually in the trunk,some are in the passenger right side kick panel. some galants do not even have one.Ex. 1995 galant s does not have one.


How do you set the clock on a 2003 Mitsubishi eclipse?

Haha, I was just struggling with this in my Mitsubishi Galant... If it's like mine you just have to *hold* the minutes or hours button and it will start progressing.Hope this'll help!


How do you set the clock on a Mitsubishi Galant?

To set the clock on a Mitsubishi Galant, first, turn on the ignition or the accessory mode. Locate the clock adjustment buttons on the dashboard or the infotainment system; these are typically labeled as "H" for hours and "M" for minutes. Press and hold the appropriate button until the time starts blinking, then use the buttons to adjust the time. Once the correct time is set, press the button again to save the changes.


How do you change the language on the Mitsubishi Galant fortis sportsback display?

To change the language on the Mitsubishi Galant Fortis Sportsback display, access the vehicle's settings menu. This is typically done by pressing the "Menu" or "Settings" button on the display or dashboard. Navigate to the language settings option and select your preferred language from the list. Confirm your selection, and the display should update to the new language.


Resetting vsc and engine service light 200 rav 4?

You can reset your engine service light by holding in the scroll button. Hold the button in until the engine oil life goes to 100 percent. The engine service light will go off.


Where is the reset button for the 'Service Engine Soon' light on a 2001 Mitsubishi mirage?

The reset button for the 'Service Engine Soon' light on a 2001 Mitsubishi Mirage is typically not a physical button, but rather a procedure that involves using an OBD-II scanner to clear the error codes. Alternatively, you can disconnect the car's battery for about 10-15 minutes to reset the light. After reconnecting the battery, the light should turn off if the underlying issue has been resolved. Always ensure that any diagnostic issues have been addressed before resetting the light.


How do you connect an mp3 player to a Mitsubishi Galant?

You are going to have to have a line in jack that connects to your mp3's hole were you put the headphones. There will usually be a place in the car that says "line in" plug the other peice into the "line in" hole in the car. There will be a button that says AUX usually by your radio push that. Then it will usually play. Unless the Galant does not have a "line in" hole


How do you Turn service light off on Mercedes actros 2648?

Go to the engine oil life display. Hold the display button in until the engine oil life reads 100 percent. Release the button and the service light will go off.


What if the reset button wiil not cut off the service engine soon light on the 2001 Oldsmobile alero?

If you are referring to the reset button inside of the fuse compartment then the answer to your question is that pushing that reset button is not meant to clear the service engine soon message. That reset button is what you would press after changing the oil (after the change oil message comes on to the left of the tachometer)... If your service engine soon message is on consistently then chances are you may have a problem with some part of your emission system.


Location of reset button on 1993 Mitsubishi 3000?

Reset button for what? If you are talking about the check engine light, there is no reset button. Unhook the battery for 5 minutes and see if that resets it. If not, then it can be reset with a scanner. Of course it will come right back on if the problem is not corrected.