On a 1996 Pontiac Grand Prix, the temperature sensor for the radiator cooling fans is typically located near the engine coolant outlet or in the engine block, often near the thermostat housing. This sensor monitors the engine temperature and signals the cooling fans to activate when the temperature reaches a certain threshold. It's important to consult the vehicle's service manual for the exact location and specifications, as there can be variations depending on the engine type.
It is the coolant temp sensor near the upper radiator hose.
Its located on the radiator passanger side about 3" below the radiator cap.
the sensor is located next to the thermostart, driver side of the cylinder head.
bottom of radiator
The computer uses the coolant temperature sensor to decide when to run the fans. It is below the radiator cap on the cylinder head.
On a 2000 Volvo S80, the engine cooling system fan is located in front of the radiator. It is mounted directly to the radiator assembly and is designed to draw air through the radiator when the engine temperature rises, helping to cool the engine. Accessing the fan typically requires removing the front grille and possibly the radiator cover.
The coolant temperature sensor on a Subaru is located on top of the engine near the upper radiator hose. It constantly updates the vehicles computer to regulate the speed of the cooling fan.
If you are talking about the coolant temperature switch that turns the fan on when the coolant reaches the right temperature, then mine it is located in the bottom of the radiator directly under the fan.
Look at the rear of the radiator approx. 1/3 down from the top
Should be located at the rear of the radiator approx. 1/3 from the top unscrew to replace
The temperature sensor on a BMW 325i is located on top of the engine, near the upper radiator hose. It constantly monitors the temperature of the coolant and triggers the cooling fan as needed.
On a 1993 Pontiac Firebird, the cooling fan temperature sensor is typically located near the thermostat housing or on the engine block, depending on the specific engine configuration. It is designed to monitor the coolant temperature and signal the cooling fan to activate when necessary to prevent overheating. To access it, you may need to remove some components for better visibility. Always refer to a service manual for precise location and replacement instructions.