answersLogoWhite

0

If its in the same location as my 96 Bonneville, It would be on the throttle body :) Almost Right below the ECM and above you're Thermostat,

If you now how to rev you're car from under the hood by pulling the cable, its connected to that. :)

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What causes the engine to idle so fast on a 1995 Buick Lesabre 3.8?

throttle position sensor believe it or not!


What is wrong when a 1996 buick lesabre is not idling?

throttle positioning sensor


Does a 1994 Buick Skylark have a throttle position sensor or a crank sensor?

It has both.


What is the fault code P0336 on a 1997 Buick lesabre?

The P0336 fault code on 1997 Buick Lesabre is a fault in the crankshaft position sensor circuit.


Where is the mass air flow sensor located on a 1993 Buick LeSabre?

directly on top of the throttle body intake


Where is location of camshaft position sensor on 1991 buick lesabre?

under the water pump.


Where is a idle sensor on a 1993 Buick Lesabre located?

The Idle Air control valve is located on the side of the throttle plate.


Installing 2001 Buick Century throttle position sensor?

How to install tps


How do you replace the throttle position sensor on a 2003 Buick rendezvous?

I just purchased the throttle sensor for a 2003 Buick rendezvous and was wondering if anyone could tell me where it located and how easy is it to put in.


What could cause a 1994 Buick LeSabre to stall when attempting to accelerate over 50mph?

the tps is bad-throttle positioning sensor


Where is coolant temp sensor for 93 Buick lesabre?

The Coolant Temperature Sensor on a 1993 & 1994 Buick LeSabre is located on driver's side of the car under the throttle body, It is screwed into the lower intake manifold. You cannot see it without first removing the throttle body since it is hidden under it. An electronic plug is clipped to the the end of the CTS.


Where is the Crankshaft sensor on a 2000 lesabre?

The 2000 Buick Regal 3.8L Crankshaft Position Sensor is located behind the harmonic balancer pulley.