answersLogoWhite

0

What else can I help you with?

Related Questions

Where do I put the transmission fluid on a 350 transmission?

Buy a transmission funnel and pour the fluid in the dipstick tube.


What is the length of a turbo 350 transmission dipstick?

It is 27 inches long.


Where do you add transmission fluid in a 350 Chevy?

Thru dipstick tube


How do you add transmission fluid to a Chevrolet 350 vortec engine?

You should never add transmission fluid to a Chevrolet 350 engine. You can add transmission fluid to the transmission through the transmission dipstick holder.


Where do you fill automatic transmission fluid in a 350?

I'm assuming you mean a Ford F-350, which you fill through the dipstick tube.


Where can you find the transmission dipstick on a 1971 Impala with a 350 Engine?

It should be on the passenger side back by the firewall.


How do you check the transmission fluid on a Ford F 350?

AnswerAUTOMATIC, Dieselpull the dipstick out it is located near the firewall on the passenger side of the vehicle the tranny must be warm and most of the time in park or netrual.


How many cylinders does a mercades GLK 350 4matic have?

I think it has 6 cylinders.


How do you check the transmission fluid on a 350 small block engine?

350 Engines dont have transmission fluid. The Transmission does. Start the engine, leave the trans in Park, pull the dipstick and look at it. fill to full mark when the engine is fully warned up


What is the length of 350 Chevy transmission dipstick?

Most often, the length is 24 inches. I have seen some that are 27 inches though.


Where do you put the transmission fluid on a 1992 dodge ram van 350?

You add the fluid down the dipstick tube under the hood.


Where is the oil dipstick located on a 2008 Mercedes CLK 350?

The oil dipstick on a 2008 Mercedes CLK 350 is located on the passenger side of the engine bay. It is positioned towards the back of the engine and is typically marked with a yellow or orange handle. To check the oil level, simply pull the dipstick out, wipe it clean, reinsert it, and then pull it out again to read the level.