On a 2008 Mercedes-Benz ML350, the transmission fill spout is located on the driver's side of the vehicle, near the rear of the engine. To access it, you may need to remove a protective cover or panel. The fill tube is typically marked and may require a special funnel or tool for filling Transmission Fluid. Always consult the owner's manual for specific instructions and safety precautions.
using a funell pour the fluid into the spout of the dipstick..slowly
The flap over the fill spout is commonly referred to as a "fill cap" or "fill cover." Its primary purpose is to prevent contaminants from entering the fill spout when not in use and to protect the spout from damage. In some contexts, it may also be called a "dust cover" or "seal."
A fill spout on a Chevy Suburban is used as the inlet for filling an FIBC.
Fill it through the dip stick spout using a special long tube funnel you can get at any auto parts store.
To efficiently fill a 5-gallon jug using a water spout, you can use a larger container to fill the jug quickly, or adjust the water flow to control the filling speed. Make sure the spout is securely positioned over the jug to avoid spills.
Fill Spout. When filling your tank with gas, you will need to open your gas tank, unscrew and remove your gas cap, remove the nozzle from the pump and put it in the fill spout.
You fill the transmission through the dipstick
When you pour it in the crankcase fill spout.
there is no fill plug u fill transmission thru the transmission dipstick tube
To fill the transmission on the Honda CRX, first use a 19 mm wrench to remove the fill plug on the side of the transmission. Then, fill the reservoir at the side of the transmission.
THERE IS NO TRANSMISSION DRAIN PLUG OR FILL PLUG. YOU WOULD FILL IT THROUGH THE TRANSMISSION DIPSTICK TUBE.
Take the fill plug out and stick your little finger in. If it isn't up to the hole, fill with 90# grease until it runs out and let it settle to level. You can get this grease at NAPA, or AutoZone, in a 1 quart plastic bottle with spout.