there isnt one. theres a plug on the side of the trannsmission.
To check the transmission fluid level on a 2001 Land Rover Discovery, start with the vehicle on a level surface and the engine running. Locate the transmission dipstick, which is usually found near the rear of the engine bay, and remove it to wipe it clean. Reinsert the dipstick fully, then remove it again to check the fluid level, which should be between the "hot" marks if the engine is warm. If the fluid is low, add the appropriate type of transmission fluid through the dipstick tube.
To check the automatic transmission fluid on a 1999 Land Rover Discovery II, first ensure the vehicle is on a level surface and the engine is running at normal operating temperature. Locate the transmission dipstick, which is typically found near the back of the engine bay, and pull it out. Wipe it clean, reinsert it fully, then pull it out again to check the fluid level against the markings on the dipstick. If needed, add the appropriate transmission fluid through the dipstick tube.
On non dipstick type transmission you cannot check the fluid level directly, but there is a bolt front of the transmission sump, unscrew and you can refill to that level.
To check the transmission fluid level on a 2007 Land Rover Discovery 3, first ensure the vehicle is parked on a level surface and the engine is running at normal operating temperature. Locate the transmission dipstick, which is typically found near the rear of the engine bay; remove it, wipe it clean, reinsert it, and then pull it out again to check the fluid level. The fluid should be within the markings on the dipstick; if it's low, add the recommended transmission fluid through the dipstick tube. Always consult the owner’s manual for specific instructions and fluid specifications.
It is important to know the types of fluids that go into different cars. A Land Rover Discovery takes Dexron III automatic transmission fluid.
where do I put trasmission fluid in landrover discovery 2
To add automatic transmission fluid to a Rover 75, locate the transmission dipstick tube, which is usually found near the back of the engine bay. Remove the dipstick, wipe it clean, and then pour the fluid through the tube using a funnel. Ensure you use the correct type of transmission fluid specified in the owner's manual, and check the fluid level with the dipstick after adding. Always add fluid gradually and check the level to avoid overfilling.
The Land Rover Discovery 3 does not have a traditional gearbox dipstick. Instead, it uses a sealed transmission system that requires checking the fluid level through a fill plug located on the side of the transmission. To check the fluid level, you typically need to access this plug underneath the vehicle, making it advisable to consult a professional or refer to the owner's manual for specific instructions.
Dextron III ATF
If a 1993 Land Rover Discovery is stuck in a low ratio gear, check the transmission fluid levels. If the fluid levels check out okay, the transmission may be experiencing a jammed gear.
To fill the automatic transmission fluid in a Rover 216i, first ensure the vehicle is on a level surface and the engine is warm. Locate the transmission dipstick, remove it, and use a funnel to add the recommended type of automatic transmission fluid through the dipstick tube. Check the fluid level using the dipstick and add more fluid if necessary, ensuring it falls within the marked range. Finally, run the engine and cycle through the gears to circulate the fluid, then recheck the level and adjust if needed.
ATF Dexron IID or Dexron III