The turn signal flasher on a 2001 Kia Rio is typically located under the dashboard, near the steering column. You may need to remove a panel or cover for access. It is a small, cylindrical component that plugs into the fuse box. If you're having trouble locating it, consulting the vehicle's service manual can provide additional guidance.
The 2001 Kia signal flasher relay switch can be found beneath the drivers side dashboard. The signal flasher relay switch will be above the brake pedal.
Under the steering column.
On a 2010 Kia Rondo, the turn signal flasher is located in the fuse box. The fuse box is typically found under the dashboard on the driver's side. To access the flasher, you may need to remove the cover of the fuse box and locate the turn signal relay, which is often labeled for easy identification.
It is quite simple to replace the flasher relay switch on your 2001 Kia. The flasher relay switch simply plugs in and out.
If the turn signal lights come on but will not flash you have a defective flasher relay. Replace the relay.
near the fuse box, under the dash on the drivers side (left side) when you turn on your blinkers its where the "blink" sound comes from.
Turn Signal Troubleshooting (check in this order):Check FuseCheck BulbsCheck Flasher RelayCheck Turn Signal Switch in steering columnMost likely its the fuse or bulb. See sources and related links below for bulb information.
The 2000 Kia Sportage signal flasher module can be found beneath the drivers side dashboard. The signal flasher module will be on the left-hand side of the brake pedal.
The turn signal/hazard flasher are controlled by the ETACS module, an integral component of the interior fuse and relay box under the driver's side dashboard. If you're sure it's the flasher, you'd probably have to replace the whole box. Check your hazards (four-ways) If they don't work either, change the switch.
2001 kia sportage will not turn any gears
If none of them flash but just come on and stay on the flasher relay is defective. If they do not even come on then the bulb is burnt out.
Remove the connector from your 2003 Kia rear turn signal. Take hold of the turn signal lightbulb, push in and turn at the same time. The lightbulb will come out. Reverse the process to install your new rear turn signal lightbulb.