It's behind the glove box, but you have to access it by removing the whole glove box assy. It is towards the top of the compartment. Difficult to see, what were they thinking?
Check under the hood in the fuse relay box.
If your turn signals aren't working on your 1990 Chrysler New Yorker, it could be due to a blown fuse, a faulty flasher relay, or a bad turn signal switch. Check the fuse box for any blown fuses and replace them if necessary. If the fuses are intact, the flasher relay may need to be replaced, or there could be an issue with the wiring or the turn signal switch itself. A thorough inspection or consulting a mechanic may help pinpoint the exact problem.
Behind center of instrument panel.
In a 2001 Chrysler Concorde, the turn signal flasher and relay are typically located in the fuse box, which is situated under the dashboard on the driver's side. You may need to remove the cover of the fuse box to access the flasher relay. Look for a cylindrical flasher unit, which is usually labeled for easy identification. Always refer to the owner’s manual for precise locations and instructions.
The turn signal flasher relay switch and the emergency flasher relay switch are the same switch. The relay switch might be labeled as the emergency flasher switch, but it is also the signal flasher relay switch.
If the bulbs and fuse are good, replace the turn signal Flasher Relay.
the turn signal/hazard flasher is located under the dash to the left of the steering column between the brake pedal and the fuse block.
how to replace the flasher on a 2000 chrysler concorde LXI
The flasher relay in Toyota Wil is in the signal light.
After replacing the burned out turn signal bulb, turn on the hazard flasher and then turn off the hazard flasher. This will reset the flashing on the turn signal from super fast to standard flashing.
The signal relay is attached to the emergency flasher on the center of the dash. Gently pry out the flasher and the relay is attached at the rear.
The turn signal relay and the flasher relay are the exact same thing. The relay switch controls the turn signals.