To add brake fluid to a 1989 Dodge Spirit, locate the brake fluid reservoir, which is typically found near the back of the engine bay on the driver's side, just behind the master cylinder. The reservoir is usually a translucent plastic container with a cap labeled for brake fluid. Ensure the vehicle is on a flat surface, remove the cap, and add the appropriate type of brake fluid until it reaches the recommended level marked on the side of the reservoir. Remember to securely replace the cap after adding fluid.
Before you add brake fluid, are you SURE you need to add some? Because as brake pads wear, the brake fluid level goes down, but the brake pads need to be replaced then, BEFORE any brake fluid is added. Otherwise, when the brake pads ARE replaced, there will be too much brake fluid in the reservoir, and it will flow out when the pistons are pushed back into it's bore, to make room for the new pads. -Tom.
Top right corner
its under the side cover
Good question. At the brake fluid resovoir
have you tried the dipstick tube.some dodge and Plymouth minivans the dipstick is the "filler hole" this also applies to the transaxle fluid.(transmission)
The fill plug is in the center rear of the case.
ADD BRAKE FLUID
You open the hood, find the brake fluid reservoir, take the cap off and add DOT 3 brake fluid up to the full level.
You can add brake fluid inside the brake fluid reservoir. The reservoir is located on the driver's side under the micro-filter panel.
Yellow cap, under the hood, driver side, near the base of the windshield.
Fill plug is located on the center rear of the transfer case