Open the driver door and look at the side of the dashboard . There is a pop off plastic cover . It is behind this .
Master cylinder usually located under the hood at the driver's side firewall
The fluid for the clutch comes from the brake fluid. After the brake master cylinder, there is a clutch master cylinder which takes fluid from the brakes. Fill up the Brake master cylinder.
Master cylinder, is the brake fluid reservoir. It is mounted on the brake booster, on the firewall, driver's side.Master cylinder, is the brake fluid reservoir. It is mounted on the brake booster, on the firewall, driver's side.
Look to see where you fill the brake fluid and where your filling the brake fluid that is the master cylinder.
Good time to replace all the brake fluid. Remove the brake lines from the Master Cylinder and pump the master cylinder dry. Add fresh brake fluid from an unopened can and bleed the master cylinder. Reinstall the brake lines and then bleed all brake lines until you see clean fluid. Keep adding fluid to the Master Cylinder until you are done.Good time to replace all the brake fluid. Remove the brake lines from the Master Cylinder and pump the master cylinder dry. Add fresh brake fluid from an unopened can and bleed the master cylinder. Reinstall the brake lines and then bleed all brake lines until you see clean fluid. Keep adding fluid to the Master Cylinder until you are done.
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
the brake resevior should be located on the driver side against the firewall,clear round cylinder with a white lid ,about 4 inches in diameter
1. Lift the bonnet 2. Locate the brake fluid cylinder its the big round thing with a white lid on it. 3. Behind this there is a smaller cylinder with a white lid about 2inches diameter. 4. This is the clutch fluid cylinder and this is where you pour the clutch fluid. 5. Don't get fluid on the bodywork or you will damage the paintwork
brake fluid container right side behind battery.
There is no fluid in the clutch....The clutch master cylinder takes DOT 3 brake fluid. It is the same fluid that you put into the brake master cylinder
Four Possible reasons... Low brake fluid - check the brake fluid level in the master cylinder Emergency brake is on - check emergency brake Low brake fluid pressure - such as a broken brake line or a bad wheel cylinder. Check the master cylinder to see if it is empty. If you add fluid and pump the pedal you will probably see brake fluid on the ground or on the inside of the tires. Possibly a bad master cylinder. - The fluid will stay full but you will have no or little brake pressure. Could be air in the system as well. BE CAREFUL If you happen to add power steering fluid or transmission fluid to the master cylinder instead of brake fluid you will destroy the system. Make sure you use ONLY brake fluid and clean the master cylinder cap off with a clean rag first so no dirt gets into the braking system.
A brake master cylinder? If you are losing brakes or brake fluid.