answersLogoWhite

0

This is a very easy thing to check. Under the hood on the left side (drivers side) near the rear of the engine bay. You will see, a small rectangle box (fluid reservoir) attached to a circle (master cylinder). Make sure the truck is turned off. On the fluid reservoir, lift the cover off. It should attach on four places, like small tabs. In side you will see a rubber boot that should stay with the cover. The fluid has two small 'holds', forward and rear respectively. There are fill level lines on the side of the reservoir. Fill them up to the line, don't over fill. Place the cover with the boot back on, ensuring it seats fully.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the fuse and relay box on a 1993 GMC suburban?

facing the engine compartment,it is on the right side,next to the brake fluid bowl.


Where is the brake light ground wire located on 1999 gmc suburban 4x4?

looking for help on the brake light ground wire location for 1999 gmc suburban 4x4


What type of fluid goes in a 94' GMC Suburban 4x4 trans case?

Dextron tranny fluid


How do you repair rear brakes on 99 GMC suburban?

replace rear brake hydrolics


What size are the speakers in a 1998 GMC suburban?

back speakers not sure what size


How do you replace the emergency brake release cable on a GMC suburban?

Your GMC Suburban emergency brake release cable is held in place with a swivel nut on each end of the cable. Loosen the swivel nut to remove the cable. Reverse the process to install the new emergency brake release cable.


How do you manually release the parking brake on 1996 gmc suburban?

Get under the driver side of the suburban by the driver door and their should be a linkage that you can loosen


Why is my 1997 gmc suburban overheating?

low radiator fluid or a possible bad thermostat.


What would make the brake calipers freeze on a 1996 GMC Jimmy?

MOISTURE IN YOUR BRAKE FLUID. FLUSH SYSTEM WITH NEW FLUID.


What type of brake fluid do you use on a 2011 GMC Yukon?

For a 2011 GMC Yukon, you should use DOT 3 or DOT 4 brake fluid. It's important to check the owner's manual for specific recommendations and to ensure the fluid meets the required specifications. Always use fresh, unopened brake fluid, and avoid mixing different types of brake fluid to maintain optimal performance.


What kind of brake fluid do you need for a 200 GMC K2500?

6zktpdot 3


How do you fix a broken brake line in a 1999 GMC Sierra?

Replace the brake line, bleed the brake. top up with brake fluid. Done.