0
Cylinder #1 is always the piston closest to the front of the engine(on a transverse mounted engine the side with the belts is the front). If it is a "V" style engine then you will notice that One cylinder head sits closer to the front of the engine than the other. The front cylinder on that side will be number 1.
What else can I help you with?
When piston number 1 is at top dead center were is piston number 6?
NUMBER6 PISTON ALSO IN top dead centre
Which is number 1 piston on 99 Chevy s10 4.3?
The number 1 piston on that motor is the first cylinder on the drivers side.
Where is the number 1 piston located on a 1973 volkswagen beetle?
Driver side, front piston.
Where is the number 1 piston on a 1993 Mazad B2600?
#1 piston is the one closest to the front of the truck. K6 mazdatruckin.com
Where is the piston 1 on the Ford Freestar?
I was told the number 1 piston is at the back side of the motor closet to the passenger side.
Where is number 1 piston on MR2 engine?
Closest to serpentine belt.
How do you find out if the number 1 piston is at top dead center?
Take number 1 plug out, put your finger in the plug hole turn motor over manually preferably, when piston is at top dead center it will blow air out of number 1 hole.
How do you locate the number one piston in Pontiac distributor cap?
That would be a neat trick. The piston will not fit into the distributor cap. Remove intake and left side head (bank 1) the #1 piston is closest to front.
What piston is number 1 in a Chevy 5.7L?
front right drivers side
Where is number 1 cylinder on a 1970 beetle?
When the point are in no 1 position and just closing no 1 piston is up.
What is the location of Number 1 piston on chevy 350 engine?
The front cylinder on the driver's side is #1.
What do you have to do when the piston is a tdc and the distributor is 180 degrees off. do we need to move the distributor?
make sure that the number 1 piston is at tdc on the compression stroke, then look and make sure the rotor is pointing at number 1. if not lift the distributor up and turn it towards the number 1 cylinder and put the number 1 wire on the cap were number 1 is, then wire it 1,8,4,3,6,5,7,2 clockwise It probably means that the piston is between the exhaust and intake cycle and that you need to turn the crankcase 360 degrees. That should put the distributor in the right place.
