0
What else can I help you with?
Can you use rubber fuel lines to replace your brake lines?
You can not use rubber fuel lines to replace the current brake lines due to the high operating pressure. You will need to replace them with brake lines, the rubber brake lines has a different construction to hold the pressure and not getting eaten away by the brake fluid, brake lines can hold over 2000psi when the pedal is heavily applied
1993 dodger ramcharger and the left front tire brakes after 10 15 miles driven.Ive changed the caliper and the lines.?
The rubber brake hose could be at fault.
What diameter are my brake lines on my s10 pick up 1995?
Front brake lines, 3/16". Front to rear, 1/4". Rear, 3/16".
What lines are attached to the master cylinder?
Brake lines and/or clutch line depending on vehicle. For brakes, the front brake lines usually attach to the frontmost connection, and the rear brake lines attach to the rearmost connection. Also of note, the front brakes typically connect to the largest of the two master cylinder reservoirs (normally the front one).
2001 Olds Alero-no brake pressure after replacing front brake pads rotors and calipers why?
It sounds like you have air in your brake lines. It sounds like you have air in your brake lines.
What is the size of a 1998 ford windstar brake line?
3/16 for a metal line. And rubber brake lines don't have sizes.
Are the brake lines on a 1997 wrangler metric?
No, the brake lines on a 1997 Wrangler are typically not metric. They are usually measured in inches.
Bleeding front brakes on a 300 Honda fourtrax?
i have recently tried doing this. On the front brake there is a bleeder on the back side on the inside. There should be a rubber cap on it. Loosen this with a screw and pump the brakes to get the air out of the lines. Good Luck
What is different between a brake line and hose?
Newer cars use brake hoses made of rubber. Older cars use brake lines made of steel.
How do you install air brake lines on a GMC c7500 for the front?
To install air brake lines on a GMC C7500 for the front, first, ensure the vehicle is safely elevated and secured. Begin by routing the new air brake lines from the air supply source to the front brake chambers, using appropriate brackets and clips to secure the lines along the frame. Connect the lines to the brake chambers, ensuring all fittings are tight and leak-free. Finally, test the system for leaks and proper operation before lowering the vehicle.
Where does the front left abs wire go?
To connect it its by the brake lines from the brake ooster on connected on the wheel weel
How do you fix a brake line on a 92 crown Victoria lx?
If you are talking about the steel brake lines, most likely the rear lines, then replace both from front to back.
