If you will notice the hazard lights are not actually flashing, reason being, the hazard flasher relay is defective. Replace it.
Honda dashboard lights are powered by a single fuse. The taillight fuse keeps the dashboard, taillights and hazard lights safe. If any of this units cause a short all of the components will not work.
94 mercury grand marque dashboard, hazard, and tail lights do not work?
Hazard lights (flashers)
Push it you will easily find that it will turn your hazard lights on.
What causes the dashboard light to stay on after your car has been turned off? 1994 Buick Century.
To turn off the hazard lights on a 2016 Ford Focus, locate the hazard light switch, which is typically found on the center console, marked by a triangle symbol. Press the switch once, and the indicator lights on the dashboard should turn off, along with the exterior hazard lights. If the lights do not turn off, ensure that the vehicle is in the "On" or "Run" position while pressing the switch.
I can't speak for all cars, however, in the ones I have owned it pertained to the hazard lights.
To turn off the hazard lights on your Renault Laguna, locate the hazard light button on the dashboard, typically marked with a red triangle symbol. Press the button once, and the lights should turn off. If the lights do not turn off, ensure the vehicle is in the correct ignition mode and try pressing the button again.
Flasher stuck in closed position defective switch
Triangle or triangle with a vertical line in the center is usually the symbol for the hazard lights
The fuse for the hazard lights on a 2001 Jeep Wrangler is located in the fuse box under the dashboard on the driver's side. You can find the fuse box by removing the cover beneath the steering column. The specific fuse for the hazard lights is usually labeled in the fuse diagram on the cover or in the owner's manual. If the hazard lights are not functioning, check this fuse for any signs of damage or a blown fuse.
On a 1997 Ford Aerostar, the hazard flasher is located on the dashboard, typically near the center console. It is a red button marked with a triangle symbol. Pressing this button activates the hazard lights, allowing all turn signal lights to flash simultaneously in case of an emergency.