answersLogoWhite

0

A car battery is not different than a beer.

The both need to have a thermo wrap to stay cold.

Another name for the battery version of the wrap is a "battery coozie"

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the backup light switch located on a 1997 dodge neon?

The backup light switch is located on the side of the transmission. It has two wires coming off of it but they are probably covered in wire wrap.


What happens when you wrap foil around a battery?

The battery becomes hot


Who do you build an electromagnet?

You take a battery and you attach each end of a wire to it then you wrap a peice of iron in the middle of the wire.


How do you open the doors on a 2000 VW Jetta with a dead battery and broken door lock?

replace/recharge the battery. either that or wrap you hand in a jacket and hulk smash the window.


How would you build an elctromagnet?

get an nail wrap insulating wire around the nail( the more times you wrap it, it stronger it is), then connect one end of the wire to the positive end of a battery and the other to the negative end.


What is it called when you wrap a wire around an iron bar and connect it to a battery?

It is called an Electromagnet, when disconnected, it loses it's magnetism.


How do I create an electro magnet?

It is easy to make an electromagnet if you have a battery, some copper wire and a nail. Just wrap the copper wire neatly and tightly (all in one direction) around the nail making sure to leave extra wire at each end of the nail to connect to the battery. The more wire you wrap, the stronger the battery will be. Attach the one end of the wire to the positive end of the battery and the other to the negative end. You have now created an electromagnet!


How do you remove the battery from a 2007 Harley Sportster?

Open the battery access panel on the left side just below the seat, pull out from the top and the plastic panel should detach relatively easily from the clips holding it on. Detach and wrap the ground. Detach the battery bracket. Pull battery out to where you can access hot lead. Detach lead without grounding. Extract battery.


How do you make a simple dc motor for project?

go to youtube they have some good stuff. you can also wrap a copper wire around a battery and put the + up and hook the wire into it. put a magnet on the bottom of the battery and there ya go!


What do you do with battery leaks?

Usually a battery will leak because of overvoltage, overtemperature or a bad battery cell. L series Saturns came equipped with a battery wrap which tended to cause the battery to overheat. The intent was to protect the rest of the engine compartment from any potential battey leaks, but the unwanted side effect was the heat. Remove the battery wrap and flush the entire area with baking soda mixed with water to remove all of the dried battery acid. Check the voltage when the engine is running. If it's much above 14 VDC at the battery, the voltage is boiling the acid right out. Have the battery tested. If one cell is shorted or damaged it can cause that or other cells to boil over.


What terminal do you attach the ten wrap to?

The ten wrap is typically attached to the positive terminal of the battery or power source. This ensures that the electrical current can flow properly through the circuit. Always ensure the connections are secure and follow safety protocols when working with electrical components.


How do you wrap a sprained paw?

To wrap a sprained paw, you just need to wrap it tight. You can wrap it with cloth or wrap it in medical tape.