0

Subjects>Auto>Auto Parts

Why does my transmission clunk and then stop or slip while in reverse then i shift to drive it slips shut truck off and start again drive works fine?

Nwall81 ∙

Lvl 1

∙ 16y ago

Updated: 12/19/2022

probably something wrong with the transmission like a gear fault or a transmission glitch or overheat. Take it to a repair shop or do some test maitanenence yourself.

Wiki User

∙ 16y ago

What else can I help you with?

Related Questions

I have a 2002 Chevy Malibu 3.1 engine what causes the transmission to clunk from park to drive or reverse when it warms up. I already replaced the trans but it still does the same?

could be bad mounts on either the tranny or engine?

Why does the transmission clunk when shifting gears?

Are you sure it is the transmission that is clunking? It could be the u-joints on the drive shaft that are making the noise. When the u-joints on the drive shaft are bad, there is an audble clunk when you accelerate and when slowing down (basically the same motions you go through when shifting gears).

What are the symptoms of a busted motor mount?

YOU WILL FEEL A CLUNK WHEN THE VEHICLE IS PLACED IIN REVERSE OR DRIVE AND IS ACCELERATED WITH THE BRAKES DEPRESSED

There are times when my 2004 4-Runner will not move when put into drive. Then there will be a pop or clunk in the rear end and the vehicle will start to move forward.?

sounds like transmission problems( not moving in drive) and u-joint problems(pop or clunk

Car will reverse but not drive?

transmission is gone.

Car goes reverse but not drive?

Get new transmission

Your truck reverse and turns on but it will not drive what could it be?

The transmission

Car will move in reverse but not drive?

bad transmission

Which type of transmission drive is noiseless?

An electric drive motor which can propel you like a transmission is very close to silent in comparison. To go in reverse just reverse the polarity.

What is the problem when the car will not go in reverse or go in drive the transmission fluid is still full?

what is the problem when the car will not go in drive or reverse? and the transmission fluid is still full

Your truck wont go in drive only reverse and drive low is it the whole transmission?

You are probably low on transmission fluids

Chevy avalanch makes a clunk when put into reverse?

it could possible be the U-Joint which is a cheap and easy fix. it's connected to your drive shaft.

Trending Questions

Where is my fuel tank located in your chrysler voyager? How do you unlock a keyless entry car with no key if the battery is dead? Your car smells like antifreeze but its not leaking? Where can you get a diagram of a 1978 Ford Dually rear axle? Where is the fuel pump reset switch on a 95 dodge intrepid? Can you use regular motor oil in Polaris sportsman 500? How do you reverse a seat belt buckle? What are the Advantages of turbo jet? What is the oil capacity of a jaguar xj8? What is the cfm rating of a rochester carburetor off a 327 cid motor? Where is the idle air control valve located on a 1993 f150 5.8 liter engine? Where is egr valve on vito 108cdi? Where is the battery on a 2004 Dodge Stratus located? What does it mean if you car squeaks when its been raining and i turn it on? Does 2012 Kia Optima have timing chain? 86 Ford Taurus serpentine belt? How much does it cost for new brakes on a Saturn SC1? Why is your car overheated but radiator full of water heater blowing cold air and knocking sound? What is the average cost to replace a catalytic converter on a 1991 Lexus LS 400? Where can you get almost all the information for a 1987 Honda Civic Si like firing order compression and timing etc?

Resources

Top Categories

Product

Company

Copyright ©2025 Answers.com. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.