answersLogoWhite

0

If the brake pad alert stays on after installing new brake pads on your 2013 Range Rover, it may be due to a few reasons. The brake pad wear sensor could be damaged or not properly connected, preventing it from resetting. Additionally, the vehicle's onboard computer may need to be reset or calibrated to recognize the new pads. Lastly, ensure that the new pads are compatible with your vehicle's system, as incorrect parts can also trigger alerts.

User Avatar

AnswerBot

4mo ago

What else can I help you with?

Related Questions

Replacing brake pads in a 2006 range rover sport HSE?

HOW DO I RESET THE PAD WARNING LIGHT ON MY RANGE ROVER


Why is your range rover stuck in neutral?

its the brake switch censer under the brake peddle itself.


How do you install a brake controller on a 2001 Range Rover?

Take it to the Land Rover dealer or any rv dealer


How do you change the brake pads on an 04 land rover range rover?

Take it to HiFlex Engineering S Yorks 01909 568681


How do you replace cabin filter range rover sport?

The cabin air filter on a Range Rover Sport is replaced by opening the access panel under the glove compartment. The filter can then be pulled out and a new filter installed.


How do you change rear brake bulb in range rover sports?

remove old bulb, insert new bulb.


What kind of car does Sidney Crosby drive?

He has a range rover


What are the models of range rover?

There are many variants in range rover but Over the following years it developed into a marque encompassing a range of four-wheel-drive models, including the Defender, Discovery, Freelander, Range Rover, Range Rover Sport and Range Rover Evoque.


How do you reset brake lights on for 2003 land rover range rover?

THIS VEHICLE THROWS A CODE WHEN ELECTRONIC WEAR SENSOR HITS ROTOR, CAUSING MESSAGE "CHECK BRAKE LINING", AND BRAKE LIGHT TO COME ON. THIS CODE MUST BE CLEARED IN VEHICLES COMPUTER BY OBD II OR EQUIV.


Is range rover German?

No. Range Rover is English.


What are the check lights on a 92 range rover looks like a circle with brackets around it?

Brake pads need to be replaced


Where is the fuse panel on a 1987 range rover that contains fuses for brake lights and horn?

To the right of the heat/air levers